PIC16CE623-04/JW データシートの表示（PDF） - Microchip Technology

部品番号

コンポーネント説明

メーカー

PIC16CE623-04/JW

OTP 8-Bit CMOS MCU with EEPROM Data Memory

Microchip Technology 

3.0 ARCHITECTURAL OVERVIEW

The high performance of the PIC16CE62X family can

be attributed to a number of architectural features

commonly found in RISC microprocessors. To begin

with, the PIC16CE62X uses a Harvard architecture, in

which, program and data are accessed from separate

memories using separate busses. This improves

bandwidth over traditional von Neumann architecture

where program and data are fetched from the same

memory. Separating program and data memory further

allows instructions to be sized differently than 8-bit

wide data word. Instruction opcodes are 14-bits wide

making it possible to have all single word instructions.

A 14-bit wide program memory access bus fetches a

14-bit instruction in a single cycle. A two-stage pipeline

overlaps fetch and execution of instructions.

Consequently, all instructions (35) execute in a sin-

gle-cycle (200 ns @ 20 MHz) except for program

branches.

The PIC16CE623 addresses 512 x 14 on-chip program

memory. The PIC16CE624 addresses 1K x 14 program

memory. The PIC16CE625 addresses 2K x 14 program

memory. All program memory is internal.

The PIC16CE62X can directly or indirectly address its

register files or data memory. All special function

registers including the program counter are mapped in

the data memory. The PIC16CE62X have an orthogo-

nal (symmetrical) instruction set that makes it possible

to carry out any operation on any register using any

addressing mode. This symmetrical nature and lack of

‘special optimal situations’ make programming with the

PIC16CE62X simple yet efficient. In addition, the

learning curve is reduced significantly.

PIC16CE62X

The PIC16CE62X devices contain an 8-bit ALU and

working register. The ALU is a general purpose

arithmetic unit. It performs arithmetic and Boolean

functions between data in the working register and any

register file.

The ALU is 8-bit wide and capable of addition,

subtraction, shift and logical operations. Unless

otherwise mentioned, arithmetic operations are two's

complement in nature. In two-operand instructions,

typically one operand is the working register

(W register). The other operand is a file register or an

immediate constant. In single operand instructions, the

operand is either the W register or a file register.

The W register is an 8-bit working register used for ALU

operations. It is not an addressable register.

Depending on the instruction executed, the ALU may

affect the values of the Carry (C), Digit Carry (DC), and

Zero (Z) bits in the STATUS register. The C and DC bits

operate as a Borrow and Digit Borrow out bit,

respectively, bit in subtraction. See the SUBLW and

SUBWF instructions for examples.

A simplified block diagram is shown in Figure 3-1, with

a description of the device pins in Table 3-1.

© 1998 Microchip Technology Inc.

Preliminary

DS40182A-page 7

Share Link: