PM9607AP
sames
USING THE SA9607P IC
The EEPROM on the SA9607AP module may be programmed in circuit with the use of a PC and a IIC interface module. The
interface module is available from SAMES and includes a IIC interface, a 7 way connector cable as well as all the components
needed to convert the module to a trim pot less meter. Figure 2 show how to connect the metering module, interface module as well
as the PC.
Live
Neutral
Load
Figure 2: PM9607AP mains connections as well as PC programming setup
To use the PM9607AP module with a SA9607P integrated
circuit the following components need to be changed:
n Insert the EEPROM from socket U3.
n Replace termination resistors R16 and R7 with 3.6W
resistor.*
n Remove Channel 2 trim-pot P1.*
n Remove P2 trim-pot. Short-circuit the trim-pot footprint.*
n Replace resistor R17 with a 24K resistor.*
n Remove jumpers J5, J6 and J7.
n Resistor R22 must be fitted if EEPROM will be
programmed in circuit.
* Component change is only require if the module should not
contain any trim-pots.
http://www.sames.co.za
3/16