RF106 データシートの表示（PDF） - Conexant Systems
部品番号
コンポーネント説明
メーカー
RF106 Datasheet PDF : 6 Pages
| |||
RF106 900 MHz Power Amplifier
Interface Description
Table 1 describes the pin signals for the RF106.
Table 1. Pin Signal Description
Pin No. Name
Description
1 RFOUT Power amplifier output
Connect to power supply through an inductor; matching network required before connecting to antenna.
2 GND1 Ground
3 MATCH Interstage matching
Connect to ground through a 1.5 nH (typical) inductor.
4 VCC1 Power supply
5 NC
Not used
Connect to ac ground, Vcc or ground (Figure 3).
6 VCC2 Power supply
Internally connected to middle stage matching network.
7 NC
Not used
Connect to ac ground, Vcc or ground (Figure 3).
8 VCC3 Power supply
9 GND2 Ground
10 ENABLE Chip enable (active high)
11 RFIN Power amplifier input
12 GND3 Ground
13 GND4 Ground
14 GND5 Ground
15 NC
Not used
Connect to ac ground, Vcc or ground (Figure 3).
16 NC
Not used
Connect to ac ground, Vcc or ground (Figure 3).
17 GND6 Ground
18 GND7 Ground
19 GND8 Ground
20 GND9 Ground
W118
Conexant
3
2/1/99
Share Link: 