DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

24AA040 データシートの表示(PDF) - Microchip Technology

部品番号
コンポーネント説明
メーカー
24AA040
Microchip
Microchip Technology Microchip
24AA040 Datasheet PDF : 22 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
25AA040/25LC040/25C040
3.5 Read Status Register (RDSR)
The RDSR instruction provides access to the STATUS
register. The STATUS register may be read at any time,
even during a write cycle. The STATUS register is
formatted as follows:
7654 3
2
1
0
X X X X BP1 BP0 WEL WIP
The Write-In-Process (WIP) bit indicates whether the
25XX040 is busy with a write operation. When set to a
1’, a write is in progress, when set to a ‘0’, no write is
in progress. This bit is read-only.
The Write Enable Latch (WEL) bit indicates the status
of the write enable latch. When set to a ‘1’, the latch
allows writes to the array, when set to a ‘0’, the latch
prohibits writes to the array. The state of this bit can
always be updated via the WREN or WRDI commands
regardless of the state of write protection on the
STATUS register. This bit is read-only.
The Block Protection (BP0 and BP1) bits indicate
which blocks are currently write-protected. These bits
are set by the user issuing the WRSR instruction. These
bits are nonvolatile.
See Figure 3-6 for RDSR timing sequence.
3.6 Write Status Register (WRSR)
The WRSR instruction allows the user to select one of
four levels of protection for the array by writing to the
appropriate bits in the STATUS register. The array is
divided up into four segments. The user has the ability
to write-protect none, one, two, or all four of the
segments of the array. The partitioning is controlled as
illustrated in Table 3-2.
See Figure 3-7 for WRSR timing sequence.
TABLE 3-2:
BP1
0
0
1
1
ARRAY PROTECTION
BP0
Array Addresses
Write-Protected
0
none
1
upper 1/4
(0180h-01FFh)
0
upper 1/2
(0100h-01FFh)
1
all
(0000h-01FFh)
FIGURE 3-6:
READ STATUS REGISTER SEQUENCE
CS
SCK
SI
SO
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Instruction
0 00 00 1 01
High-impedance
Data from STATUS register
7 6 54 3 2 10
FIGURE 3-7:
WRITE STATUS REGISTER SEQUENCE
CS
SCK
SI
SO
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Instruction
Data to STATUS register
0 00 00 0 01 7 6 54 3 2 10
High-impedance
DS21204E-page 10
© 2006 Microchip Technology Inc.

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]