MAX1487(2003) データシートの表示（PDF） - Maxim Integrated
部品番号
コンポーネント説明
メーカー
MAX1487 Datasheet PDF : 19 Pages
| |||
Low-Power, Slew-Rate-Limited
RS-485/RS-422 Transceivers
TOP VIEW
VCC 1
R
RO 2
DI 3
GND 4 D
VCC
VCC
8A
7B
1
MAX488
MAX490
6Z
5Y
5Y
3
DI
D
6Z
Rt
R
RO
DIP/SO
B1
A2
VCC 3
RO 4
MAX488
MAX490
8Z
7Y
6 GND
5 DI
2
RO
8A
R
Rt
7
B
4
GND
D
DI
GND
µMAX
NOTE: TYPICAL OPERATING CIRCUIT SHOWN WITH DIP/SO PACKAGE.
Figure 2. MAX488/MAX490 Pin Configuration and Typical Operating Circuit
TOP VIEW
DE VCC
4 14
MAX489
MAX491
VCC RE
N.C. 1
RO 2
R
RE 3
14 VCC
13 N.C.
12 A
DI
5
D
9Y
10
Z
Rt
R
RO
DE 4
11 B
DI 5
10 Z
RO
2
D
GND 6
9Y
GND 7
8 N.C.
NC 1, 8, 13
12 A
R
Rt
11
B
D
DI
DIP/SO
3
6, 7
RE GND
GND DE
Figure 3. MAX489/MAX491 Pin Configuration and Typical Operating Circuit
__________Applications Information
The MAX481/MAX483/MAX485/MAX487–MAX491 and
MAX1487 are low-power transceivers for RS-485 and RS-
422 communications. The MAX481, MAX485, MAX490,
MAX491, and MAX1487 can transmit and receive at data
rates up to 2.5Mbps, while the MAX483, MAX487,
MAX488, and MAX489 are specified for data rates up to
250kbps. The MAX488–MAX491 are full-duplex trans-
ceivers while the MAX481, MAX483, MAX485, MAX487,
and MAX1487 are half-duplex. In addition, Driver Enable
(DE) and Receiver Enable (RE) pins are included on the
MAX481, MAX483, MAX485, MAX487, MAX489,
MAX491, and MAX1487. When disabled, the driver and
receiver outputs are high impedance.
MAX487/MAX1487:
128 Transceivers on the Bus
The 48kΩ, 1/4-unit-load receiver input impedance of the
MAX487 and MAX1487 allows up to 128 transceivers
on a bus, compared to the 1-unit load (12kΩ input
impedance) of standard RS-485 drivers (32 trans-
ceivers maximum). Any combination of MAX487/
MAX1487 and other RS-485 transceivers with a total of
32 unit loads or less can be put on the bus. The
MAX481/MAX483/MAX485 and MAX488–MAX491 have
standard 12kΩ Receiver Input impedance.
8 _______________________________________________________________________________________
Share Link: 