VS-751(2009) データシートの表示（PDF） - Vectron International
部品番号
コンポーネント説明
メーカー
VS-751 Datasheet PDF : 8 Pages
| |||
Parameter
Power Supply
Input Current
Output Current
Voltage
Storage Temperature
Soldering Temperature / Duration
Absolute Maximum Ratings
Symbol
V
CC
I
IN
I
OUT
V
C
TSTR
T /t
PEAK P
Ratings
0 to 6
100
25
0 to V
CC
-55 to 125
260 / 40
Unit
V
mA
mA
V
°C
°C / sec
Stresses in excess of the absolute maximum ratings can permanently damage the device. Also, exposure to these absolute
maximum ratings for extended periods may adversly affect device reliability. Functional operation is not implied at these or any
other conditions in excess of those represented in the operational sections of this datasheet. Permanent damage is also possible
if any device input (Vc or FS) draws greater than 100mA.
Suggested Output Load Configuration
LV-PECL to LV-PECL: For short transmission lengths, the power
consumption could be reduced by removing the 100Ω resistor and
doubling the value of the pull down resistors.
LV-PECL to LVDS: Restricted for short transmission lengths.
Configuration may require modification depending on LVDS receiver.
Functional Test: Allows standard power supply configuration.
Since AC coupled, the LV-PECL levels cannot be measured.
Production Test: Allows direct DC coupling into 50Ω measurement
equipment. Must bias the power supplys as shown. Similiar to Figure 1.
Page3 of 8
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Rev: 11/12/2009
Share Link: 