ATMEGA16U4(2008) データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

ATMEGA16U4
(Rev.:2008)

8-bit Microcontroller with 16/32K Bytes of ISP Flash and USB Controller

Atmel Corporation 

Only bits 6 and 7 are present on the product pinout.

Port C also serves the functions of special features of the ATmega16U4/ATmega32U4 as listed

on page 73.

2.2.5

Port D (PD7..PD0)

Port D is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The

Port D output buffers have symmetrical drive characteristics with both high sink and source

capability. As inputs, Port D pins that are externally pulled low will source current if the pull-up

resistors are activated. The Port D pins are tri-stated when a reset condition becomes active,

even if the clock is not running.

Port D also serves the functions of various special features of the ATmega16U4/ATmega32U4

as listed on page 75.

2.2.6

Port E (PE6,PE2)

Port E is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The

Port E output buffers have symmetrical drive characteristics with both high sink and source

capability. As inputs, Port E pins that are externally pulled low will source current if the pull-up

resistors are activated. The Port E pins are tri-stated when a reset condition becomes active,

even if the clock is not running.

Only bits 2 and 6 are present on the product pinout.

Port E also serves the functions of various special features of the ATmega16U4/ATmega32U4

as listed on page 78.

2.2.7

Port F (PF7..PF4, PF1,PF0)

Port F serves as analog inputs to the A/D Converter.

Port F also serves as an 8-bit bi-directional I/O port, if the A/D Converter channels are not used.

Port pins can provide internal pull-up resistors (selected for each bit). The Port F output buffers

have symmetrical drive characteristics with both high sink and source capability. As inputs, Port

F pins that are externally pulled low will source current if the pull-up resistors are activated. The

Port F pins are tri-stated when a reset condition becomes active, even if the clock is not running.

Bits 2 and 3 are not present on the product pinout.

Port F also serves the functions of the JTAG interface. If the JTAG interface is enabled, the pull-

up resistors on pins PF7(TDI), PF5(TMS), and PF4(TCK) will be activated even if a reset occurs.

2.2.8 D-

USB Full speed / Low Speed Negative Data Upstream Port. Should be connected to the USB D-

connector pin with a serial 22 Ohms resistor.

2.2.9 D+

USB Full speed / Low Speed Positive Data Upstream Port. Should be connected to the USB D+

connector pin with a serial 22 Ohms resistor.

2.2.10 UGND

USB Pads Ground.

6 ATmega16U4/ATmega32U4

7766BS–AVR–07/08

Share Link: