19-223-R6G6C-A01-2T データシートの表示（PDF） - EVERLIGHT

部品番号

コンポーネント説明

メーカー

19-223-R6G6C-A01-2T

Chip LED with Bi-Color(Multi-Color)

EVERLIGHT 

EVERLIGHT ELECTRONICS CO.,LTD.

Precautions For Use

19-223/R6G6C-A01/2T

1. Over-current-proof

Customer must apply resistors for protection , otherwise slight voltage shift will cause big

current change ( Burn out will happen ).

2. Storage

2.1 Do not open moisture proof bag before the products are ready to use.

2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.

2.3 After opening the package: The LED's floor life is 1 year under 30℃ or less and 60% RH or less.

If unused LEDs remain, it should be stored in moisture proof packages.

2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the

storage time, baking treatment should be performed using the following conditions.

Baking treatment : 60±5℃ for 24 hours.

3. Soldering Condition

3.1 Pb-free solder temperature profile

3.2 Reflow soldering should not be done more than two times.

3.3 When soldering, do not put stress on the LEDs during heating.

3.4 After soldering, do not warp the circuit board.

4.Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds

within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do

soldering of each terminal. Be careful because the damage of the product is often started at the time of the

hand solder.

Everlight Electronics Co., Ltd.

Device No: SZDSE-192-A25

http://www.everlight.com

Prepared date: 7-Nov-2006

Rev 1 Page: 10 of 11

Prepared by: Xiaoyan

Share Link: