M29F002BB データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

M29F002BB

2 Mbit (256Kb x8, Boot Block) Single Supply Flash Memory

STMicroelectronics 

M29F002BT, M29F002BB, M29F002BNT, M29F002BNB

SIGNAL DESCRIPTIONS

See Figure 1, Logic Diagram, and Table 1, Signal

Names, for a brief overview of the signals connect-

ed to this device.

Address Inputs (A0-A17). The Address Inputs

select the cells in the memory array to access dur-

ing Bus Read operations. During Bus Write opera-

tions they control the commands sent to the

Command Interface of the internal state machine.

Data Inputs/Outputs (DQ0-DQ7). The Data In-

puts/Outputs output the data stored at the selected

address during a Bus Read operation. During Bus

Write operations they represent the commands

sent to the Command Interface of the internal state

machine.

Chip Enable (E). The Chip Enable, E, activates

the memory, allowing Bus Read and Bus Write op-

erations to be performed. When Chip Enable is

High, VIH, all other pins are ignored.

Output Enable (G). The Output Enable, G, con-

trols the Bus Read operation of the memory.

Write Enable (W). The Write Enable, W, controls

the Bus Write operation of the memory’s Com-

mand Interface.

Reset/Block Temporary Unprotect (RP). The Re-

set/Block Temporary Unprotect pin can be used to

apply a Hardware Reset to the memory or to tem-

porarily unprotect all blocks that have been pro-

tected. On the M29F002BNT the pin is not

connected internally and this feature is not avail-

able.

A Hardware Reset is achieved by holding Reset/

Block Temporary Unprotect Low, VIL, for at least

tPLPX. After Reset/Block Temporary Unprotect

goes High, VIH, the memory will be ready for Bus

Read and Bus Write operations after tPHEL

or tPLYH, whichever occurs last. See Table 15 and

Figure 12, Reset/Temporary Unprotect AC Char-

acteristics for more details.

Holding RP at VID will temporarily unprotect the

protected blocks in the memory. Program and

Erase operations on all blocks will be possible.

The transition from VIH to VID must be slower than

tPHPHH.

Reset/Block Temporary Unprotect can be left un-

connected. A weak internal pull-up resistor en-

sures that the memory always operates correctly.

VCC Supply Voltage. The VCC Supply Voltage

supplies the power for all operations (Read, Pro-

gram, Erase etc.).

The Command Interface is disabled when the VCC

Supply Voltage is less than the Lockout Voltage,

VLKO. This prevents Bus Write operations from ac-

cidentally damaging the data during power up,

power down and power surges. If the Program/

Erase Controller is programming or erasing during

this time then the operation aborts and the memo-

ry contents being altered will be invalid.

A 0.1µF capacitor should be connected between

the VCC Supply Voltage pin and the VSS Ground

pin to decouple the current surges from the power

supply. The PCB track widths must be sufficient to

carry the currents required during program and

erase operations, ICC4.

VSS Ground. The VSS Ground is the reference for

all voltage measurements.

4/22

Share Link: