25LCXXXA
4.0 DATA PROTECTION
The following protection has been implemented to
prevent inadvertent writes to the array:
• The write enable latch is reset on power-up
• A write enable instruction must be issued to set
the write enable latch
• After a byte write, page write or STATUS register
write, the write enable latch is reset
• CS must be set high after the proper number of
clock cycles to start an internal write cycle
• Access to the array during an internal write cycle
is ignored and programming is continued
5.0 POWER-ON STATE
The 25LCXXXA powers on in the following state:
• The device is in low-power Standby mode
(CS = 1)
• The write enable latch is reset
• SO is in high-impedance state
• A high-to-low-level transition on CS is required to
enter active state
TABLE 5-1: WRITE-PROTECT FUNCTIONALITY MATRIX
WP
(pin 3)
0 (low)
1 (high)
1 (high)
x = don’t care
WEL
(SR bit 1)
x
0
1
Protected Blocks
Protected
Protected
Protected
Unprotected Blocks
Protected
Protected
Writable
STATUS Register
Protected
Protected
Writable
DS22136B-page 14
Preliminary
© 2009 Microchip Technology Inc.