ACST67S データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

ACST67S

OVER VOLTAGE PROTECTED AC POWER SWITCH

STMicroelectronics 

ACST6

AC LINE SWITCH BASIC APPLICATION

The ACST6-7S device is especially designed to drive medium power induction motors in refrigerators,

dish washers, and tumble dryers.

Pin COM

: Common drive reference, to be connected to the power line neutral

Pin G

: Switch Gate input to be connected to the controller

Pin OUT

: Switch Output to be connected to the load

When driven from a low voltage controller, the ACST switch is triggered with a negative gate current flow-

ing out of the gate pin G. It can be directly driven by the controller through a resistor as shown on the typ-

ical application diagram. In appliance systems, the ACST6-7S switch intends to drive medium power load

in ON / OFF full cycle or phase angle control mode.

Thanks to its thermal and turn-off commutation characteristics, the ACST6-7S switch is able to drive an

inductive load up to 6A without a turn-off aid snubber circuit.

Figure 2: Typical Application Diagram

Run

Start

OUT

G

COM

ST 62/72

MCU

Run

Start

OUT

G

COM

ST 62/72

MCU

AC LINE TRANSIENT VOLTAGE RUGGEDNESS

The ACST6-7S switch is able to safely withstand the AC line transient voltages either by clamping the low

energy spikes or by breaking over under high energy shocks.

The test circuit in figure 3 is representative of the ACST application and is used to test the ACST switch

according to the IEC61000-4-5 standard conditions. Thanks to the load impedance, the ACST switch with-

stands voltage spikes up to 2 kV above the peak line voltage by breaking over safely. Such non-repetitive

testing can be done 10 times on each AC line voltage polarity.

Figure 3: Overvoltage ruggedness test circuit for resistive and inductive loads according to

IEC61000-4-5 standard R = 10Ω, L = 5µH & VPP = 2kV

SURGE VOLTAGE

AC LINE & GENERATOR

R

L

VAC + VPP

OUT

G

COM

4/10

®

Share Link: