ADT7470 データシートの表示（PDF） - Analog Devices

部品番号

コンポーネント説明

メーカー

ADT7470

Temperature Sensor Hub and Fan Controller

Analog Devices 

ADT7470

PIN CONFIGURATION AND FUNCTION DESCRIPTIONS

SCL 1

GND 2

VCC 3

TACH3 4

PWM2 5

TACH1 6

TACH2 7

PWM3 8

ADT7470

TOP VIEW

(Not to Scale)

16 SDA

15 PWM1

14 SMBALERT

13 FULL_SPEED/TMP_START

12 TMP_IN

11 ADDR

10 PWM4

9 TACH4

Figure 3. Pin Configuration

Data Sheet

Table 4. Pin Function Descriptions

Pin No. Mnemonic Description

1

SCL

Digital Input (Open Drain). SMBus serial clock input. Requires SMBus pull-up, typically 2k2Ω.

2

GND

Ground Pin.

3

VCC

Power Supply Pin.

4

TACH3

Digital Input (Open Drain). Fan tachometer input to measure the speed of Fan 3.

5

PWM2

Digital I/O (Open Drain). Requires 10 kΩ typical pull-up. Pulse-width modulated output to control

the speed of Fan 2. Can be configured as GPIO by setting Bit 0x7F[2] = 1.

6

TACH1

Digital Input (Open Drain). Fan tachometer input to measure the speed of Fan 1.

7

TACH2

Digital Input (Open Drain). Fan tachometer input to measure the speed of Fan 2.

8

PWM3

Digital I/O (Open Drain). Pulse-width modulated output to control the speed of Fan 3.

Requires 10 kΩ typical pull-up. Can be configured as GPIO by setting Bit 0x7F[1] = 1.

9

TACH4

Digital Input (Open Drain). Fan tachometer input to measure the speed of Fan 4.

10

PWM4

Digital I/O (Open Drain). Pulse-width modulated output to control the speed of Fan 4.

Requires 10 kΩ typical pull-up. Can be configured as GPIO by setting Bit 0x7F[0] = 1.

11

ADDR

Three-state Input. Used to set the SMBus device address.

12

TMP_IN

Digital Input (Open Drain). PWM input to PWM processing engine that interprets daisy-chained output

from multiple TMP05 temperature sensors. Readings from individual TMP05 temperature sensors are

available by reading the temperature reading registers over the SMBus.

13

FULL_SPEED Digital Input Active Low (Open Drain). This input blasts the fans to maximum speed when the pin is pulled low

externally. Do not leave pin 13 open when not I use, tie to VCC.

13

TMP_START Digital Output (Open Drain). This pin can be used as an output to start daisy-chained temperature

measurements from TMP05 or TMP06 temperature sensors. Requires 10 kΩ typical pull-up.

14

SMBALERT Digital Output Active Low (Open Drain). This pin can be reconfigured as an SMBALERT interrupt output

to signal out-of-limit conditions such as fan failures.

15

PWM1

Digital I/O (Open Drain). Pulse-width modulated output to control the speed of Fan 1.

Requires 10 kΩ typical pull-up. Can be configured as GPIO by setting Bit 0x7F[3] = 1.

16

SDA

Digital I/O (Open Drain). SMBus bidirectional serial data. Requires SMBus pull-up, typically 2k2Ω.

Rev. E | Page 6 of 40

Share Link: