AM24LC16 データシートの表示（PDF） - Anachip Corporation

部品番号

コンポーネント説明

メーカー

AM24LC16

2-Wire Serial 16K-bits (2048 x 8) CMOS Electrically Erasable PROM

Anachip Corporation 

2-Wire Serial 16K-bits (2048 x 8) CMOS Electrically Erasable PROM

ATC

AM24LC16

Write Operations (Continued)

Current Address Read

The AM24LC16 contains an address counter that

maintains the address of the last accessed word,

internally incremented by one. Therefore if the

previous access (either a read or write operation )

was to address n, the next current address read

operation would access data from address n + 1.

Upon receipt of the slave address with R/W bit set to

one, the AM24LC16 issues an acknowledge and

transmits the eight bit data word . The master will

not acknowledge the transfer but does generate a

stop condition and the AM24LC16 discontinues

transmission. (Shown in Figure 6)

Random Read

Random read operations allow the master to access

any memory location in a random manner. To

perform this type of read operation, first the word

address must be set. This is done by sending the

word address to the AM24LC16 as part of a write

operation. After the word address is sent, the master

generates a start condition following the

acknowledge. This terminates the write operation,

but not before the internal address pointer is set.

Then the master issues the control byte again but

with R/W bit set to a one. The AM24LC16 will then

issue an acknowledge and transmit the eight bit data

word. The master will not acknowledge the transfer

but does generate a stop condition and the

AM24LC16 discontinues transmission. (Shown in

Figure 7)

Sequential Read

Sequential read is initiated in the same way as a

random read except that after the AM24LC16

transmits the first data byte, the master issues an

acknowledge as opposed to a stop condition in a

random read. This directs the AM24LC16 to transmit

the next sequentially addressed 8 bit byte (Shown in

Figure 8). To provide sequential read the

AM24LC16 contains an internal address pointer

which is incremented by one at the completion of

each operation.

Noise Protection

The SCL and SDA inputs have filter circuits which

suppress noise spikes to assure proper device

operation even on a noisy bus.

Anachip Corp.

www.anachip.com.tw

Rev. A1 Oct 20, 2003

6/10

Share Link: