AN7195_ データシートの表示（PDF） - Panasonic Corporation

部品番号

コンポーネント説明

メーカー

AN7195_

Dual 15 W BTL power IC for car audio

Panasonic Corporation 

AN7195Z

ICs for Audio Common Use

s Technical Information (continued)

[2] Application note (continued)

2. Oscillation countermeasures

1) In order to increase the oscillation allowance, connect a capacitor and

a resistor in series between each output terminal and GND as shown

in figure 2.

2) The use of polyester film capacitor having a little fluctuation with

temperature and frequency is recommended as the 0.1 µF capacitor

for oscillation prevention.

1

2,4

13,15

To speaker

0.1 µF

2.2 Ω

3,14

3. Input terminal

Figure 2

1) The reference voltage of input terminal is 0 V. When the input signal has a reference voltage other than 0 V

potential, connect a coupling capacitor (of about several µF) for DC component cut in series with the input

terminal. Check the low-pass frequency characteristics to determine the capacitor value.

2) 10 kΩ or less of signal source impedance Rg can reduce the output end noise voltage.

3) The output offset voltage fluctuates when the signal source impedance Rg is changed. A care must be taken

when using the circuit by directly connecting the volume to the input terminal. In such a case, the use of

coupling capacitor is recommended.

4) If a high frequency signal from tuners enters the input terminal as noise, insert a capacitor of approx. 0.01 µF

between the input terminal and input GND.

When a high frequency signal is inputted, malfunction in protective circuits may occur.

15 µA 15 µA

1 µF

Input signal

0.01 µF

6 200 Ω

4.7 kΩ 11

30 kΩ

400 Ω

To power

Attenuator

Figure 3

4. Ripple filter

1) In order to suppress the fluctuation of supply voltage, connect a capacitor of approx. 33 µF between RF

terminal (pin12) and GND.

2) Relation between RR (Ripple Rejection Ratio) and a capacitor

The larger the capacitance of the ripple filter is, the better the ripple rejection becomes.

3) Relation between the rise time of circuit and a capacitor

The larger the capacitance of the ripple filter is, the longer the time from the power on (standby high) to the

sound release becomes.

4) The DC voltage of output terminal is approximately the middle point of the ripple filter terminal voltage.

5) The internal circuit of ripple filter terminal is as shown in figure 4 and the charge current is approx. 3 mA to

10 mA.

6) The muting circuit turns on when the ripple filter terminal is VCC − 4 VBE or less.

For that reason, abnormal sound due to waveform distortion at rising and falling of the circuit is not released.

8

Share Link: