HT93LC56 データシートの表示（PDF） - Holtek Semiconductor

部品番号

コンポーネント説明

メーカー

HT93LC56

2K 3-Wire CMOS Serial EEPROM

Holtek Semiconductor 

HT93LC56

ERASE

The ERASE instruction erases data at the

specified addresses in the programming enable

mode. After the ERASE op-code and the speci-

fied address have been issued, the data erase is

activated by the falling edge of CS. Since the

internal auto-timing generator provides all tim-

ing signals for the internal erase, so the SK

clock is not required. During the internal erase,

we can verify the busy/ready status if CS is

high. The DO pin will remain low but when the

operation is over, the DO pin will return to high

and further instructions can be executed.

WRITE

The WRITE instruction writes data into the

device at the specified addresses in the pro-

gramming enable mode. After the WRITE op-

code and the specified address and data have

been issued, the data writing is activated by the

falling edge of CS. Since the internal auto-tim-

ing generator provides all timing signal for the

internal writing, so the SK clock is not required.

The auto-timing write cycle includes an auto-

matic erase-before-write capability. So, it is not

necessary to erase data before the WRITE in-

struction. During the internal writing, we can

verify the busy/ready status if CS is high. The

DO pin will remain low but when the operation

is over, the DO pin will return to high and

further instructions can be executed.

ERAL

The ERAL instruction erases the entire 128×16

or 256×8 memory cells to logical “1” state in the

programming enable mode. After the erase-all

instruction set has been issued, the data erase

feature is activated by the falling edge of CS.

Since the internal auto-timing generator pro-

vides all timing signal for the erase-all opera-

tion, so the SK clock is not required. During the

internal erase-all operation, we can verify the

busy/ready status if CS is high. The DO pin will

remain low but when the operation is over, the

DO pin will return to high and further instruc-

tion can be executed.

WRAL

The WRAL instruction writes data into the en-

tire 128×16 or 256×8 memory cells in the pro-

gramming enable mode. After the write-all

instruction set has been issued, the data writ-

ing is activated by the falling edge of CS. Since

the internal auto-timing generator provides all

timing signals for the write-all operation, so the

SK clock is not required. During the internal

write-all operation, we can verify the

busy/ready status if CS is high. The DO pin will

remain low but when the operation is over the

DO pin will return to high and further instruc-

tion can be executed.

6

6th May ’99

Share Link: