APW7060 データシートの表示（PDF） - Anpec Electronics

部品番号

コンポーネント説明

メーカー

APW7060

Dual Controllers - Step Down Synchronous PWM and Linear Controller

Anpec Electronics 

APW7060

Dual Controllers - Step Down Synchronous PWM and Linear Controller

Features

General Description

• Provides Two Regulated Voltages

- One Synchronous DC/DC Buck Controller

- One Linear Controller

• 0.8V Internal Reference Voltage

- Both Controllers: 0.8V ± 2% Line, Load

and Temp.

• Output Voltage Range

- PWM Controller : 0.8V to VIN

- Linear Controller : 0.8V to (12VCC-V )

GSpass

• Full Duty Cycle Range for PWM Controller

- 0% to 100%

• Internal Loop Compensation for PWM Controller

• Internal 2ms Soft Start and Short Circuit Protec

tion for both Controllers

• Both Controllers Drive N-Channel MOSFETs

• Small Converter Size

- 600kHz Constant Switching Frequency

- Simple SO-14 Package

• Shutdown Control

Applications

• Motherboard

• Graphics Cards

• 12V, 5V and 3.3V Inputs DC-DC Converter

• DSP Supplies

• Embedded processor and I/O supplies

The APW7060 integrates a synchronous buck PWM

controller and a linear controller to provide two regu-

lated voltages in a single package. The PWM control-

ler drives external N-channel MOSFETs and operates

at a fixed 600kHz frequency. When the input supply

drops close to the output, the upper MOSFET remains

on, achieving 100% duty cycle. Internal loop compen-

sation is optimized for fast transient response, elimi-

nating external compensation network. The linear con-

troller drives an external N-channel MOSFET to form a

linear regulator. The internal 0.8V reference makes this

part suitable for a wide variety of low voltage

applications.

The APW7060 has an undervoltage lockout circuitry

to ensures that both the 5VCC and 12VCC must be

present before its internal circuitry is power up. Soft

start is internally set to 2ms and will bring both out-

puts into regulation in a controlled manner. When ei-

ther output goes into short, soft start will be initiated.

If the short condition still remains after three cycles,

both regulators will be shut down. To restart both

regulators, recycle the voltage at 5VCC or 12VCC pin

or momentarily pull the FB2 pin above 1.28V.

The APW7060 can be shutdown by pulling the FB2

pin above 1.28V. In shutdown, all gate drive signals

will be low. This dual controller is available in SO-14

package.

Pinouts

LGATE 1

GND 2

GND 3

5VCC 4

DRIVE2 5

FB2 6

NC 7

14 UGATE

13 12VCC

12 NC

11 NC

10 NC

9 FB

8 NC

ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and advise

customers to obtain the latest version of relevant information to verify before placing orders.

Copyright  ANPEC Electronics Corp.

1

Rev. A.3 - Oct., 2003

www.anpec.com.tw

Share Link: