AS2702-16T データシートの表示（PDF） - austriamicrosystems AG
部品番号
コンポーネント説明
メーカー
AS2702-16T Datasheet PDF : 13 Pages
| |||
AS2702 – AS-Interface Slave IC
Data Port Pins D3, …, D0 and Data Strobe Pin DSTBn
Basically data port D3, …, D0 is designed for bidirectional data transfer out of and into the slave device. Each data port pin is
equipped with both a low-side open-drain output stage as well as an input stage to this purpose.
Depending on the so-called IO-configuration code, written and stored in the slave device, each data port pin is individually set to
behave as
• output, or
• output/input, or
• input.
The timing of the data transfer is presented in Figure 3.
Strobe signal DSTBn flags and governs the data transfer as follows:
a) data port pin is set ‘output’:
output data become valid upon the HL-edge of the strobe and will remain so until the next HL-edge, hence during the entire
strobe cycle;
b) data port pin is set ‘output/input’:
output data become valid upon the HL-edge of the strobe and will remain so until it’s LH-edge; input data to be valid within a
specific time window relative to the HL-edge, after completion of the strobe’s L-phase;
c) data port pin is set ‘input’:
input data to be valid within a specific time window relative to the HL-edge of the strobe, after completion of the strobe’s
L-phase.
If necessary, output data as per a) and b) can be easily latched with the LH-edge of strobe DSTBn as they will remain valid for
about 0.4µs beyond as a minimum.
Care must be taken however, that signal delay added by external circuitry is lower for the strobe than for the data.
Dx
Dx
t
STB
Data out
tDSTBn + 0.4 µs
Data out
t + t DSTBn
OUTOFF
Data in
Data in
DSTBn
t
DSTBn
t
INPmin
tINPmax
Figure 3 Timing of data transfer at data port D3, …, D0 relative to strobe DSTBn
The following table specifies the timing parameters relating to Figure 3:
Symbol Parameter
Min
tSTB
Delay DSTBn HL-edge to Dx output data valid
tDSTBn DSTBn strobe width
6
tOUTOFF Delay DSTBn LH-edge to Dx output off
0.2
tINP
Input data valid time window
10.5
Revision 1.3, 21-Aug-08
Max
Unit Note
1.5
µs
6.8
µs 1
1
µs 2
12.5
µs 3
Page 6 of 13
Share Link: 