AT24C16B データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

AT24C16B

Two-wire Serial EEPROM

Atmel Corporation 

5. Device Operation

CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an external device.

Data on the SDA pin may change only during SCL low time periods (see Figure 7-2 on page 8).

Data changes during SCL high periods will indicate a start or stop condition as defined below.

START CONDITION: A high-to-low transition of SDA with SCL high is a start condition which

must precede any other command (see Figure 7-3 on page 8).

STOP CONDITION: A low-to-high transition of SDA with SCL high is a stop condition. After a

read sequence, the stop command will place the EEPROM in a standby power mode (see Fig-

ure 7-3 on page 8).

ACKNOWLEDGE: All addresses and data words are serially transmitted to and from the

EEPROM in 8-bit words. The EEPROM sends a zero to acknowledge that it has received each

word. This happens during the ninth clock cycle.

STANDBY MODE: The AT24C16B features a low-power standby mode which is enabled: (a)

upon power-up and (b) after the receipt of the STOP bit and the completion of any internal

operations.

2-WIRE SOFTWARE RESET: After an interruption in protocol, power loss or system reset, any

2-wire part can be protocol reset by following these steps:

1. Create a start bit condition.

2. Clock 9 cycles.

3. Create another start bit followed by stop bit condition as shown below.

Start bit

SCL

1

Dummy Clock Cycles

2

3

8

Start bit

9

Stop bit

SDA

6 AT24C16B

5175D–SEEPR–6/08

Share Link: