AT24C01A-W2.7-11 データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

AT24C01A-W2.7-11

Two-wire Serial EEPROM 1K (128 x 8) 2K (256 x 8) 4K (512 x 8) 8K (1024 x 8) 16K (2048 x 8)

Atmel Corporation 

Device Operation

CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an exter-

nal device. Data on the SDA pin may change only during SCL low time periods (see

Figure 4 on page 7). Data changes during SCL high periods will indicate a start or stop

condition as defined below.

START CONDITION: A high-to-low transition of SDA with SCL high is a start condition

which must precede any other command (see Figure 5 on page 8).

STOP CONDITION: A low-to-high transition of SDA with SCL high is a stop condition.

After a read sequence, the stop command will place the EEPROM in a standby power

mode (see Figure 5 on page 8).

ACKNOWLEDGE: All addresses and data words are serially transmitted to and from the

EEPROM in 8-bit words. The EEPROM sends a zero to acknowledge that it has

received each word. This happens during the ninth clock cycle.

STANDBY MODE: The AT24C01A/02/04/08A/16A features a low-power standby mode

which is enabled: (a) upon power-up and (b) after the receipt of the STOP bit and the

completion of any internal operations.

MEMORY RESET: After an interruption in protocol, power loss or system reset, any 2-

wire part can be reset by following these steps:

1. Clock up to 9 cycles.

2. Look for SDA high in each cycle while SCL is high.

3. Create a start condition.

6 AT24C01A/02/04/08A/16A

0180V–SEEPR–8/05

Share Link: