AT25320B-CUL-T(2012) データシートの表示（PDF） - Atmel Corporation
部品番号
コンポーネント説明
メーカー
AT25320B-CUL-T Datasheet PDF : 24 Pages
| |||
Write Status Register (WRSR): The WRSR instruction allows the user to select one of four levels of protection. The
AT25320B/640B is divided into four array segments. One-quarter, one-half, or all of the memory segments can be
protected. Any of the data within any selected segment will therefore be read-only. The Block Write Protection levels and
corresponding status register control bits are shown in Table 5-4.
The three bits BP0, BP1, and WPEN are nonvolatile cells that have the same properties and functions as the regular
memory cells (e.g., WREN, tWC, RDSR).
Table 5-4. Block Write Protect Bits
Level
0
1(1/4)
2(1/2)
3(All)
Status Register Bits
BP1
BP0
0
0
0
1
1
0
1
1
Array Addresses Protected
AT25320B
AT25640B
None
None
0C000FFF
18001FFF
08000FFF
10001FFF
00000FFF
00001FFF
The WRSR instruction also allows the user to enable or disable the Write Protect (WP) pin through the use of the Write
Protect Enable (WPEN) bit. Hardware Write Protection is enabled when the WP pin is low and the WPEN bit is one.
Hardware Write Protection is disabled when either the WP pin is high or the WPEN bit is zero. When the device is
hardware write protected, writes to the status register, including the Block Protect bits and the WPEN bit, and the
block-protected sections in the memory array are disabled. Writes are only allowed to sections of the memory that are
not block-protected.
Note: When the WPEN bit is Hardware Write Protected, it cannot be changed back to zero as long as the WP pin is
held low.
Table 5-5. WPEN Operation
WPEN
0
0
1
1
X
X
WP
X
X
Low
Low
High
High
WEN
0
1
0
1
0
1
Protected
Blocks
Protected
Protected
Protected
Protected
Protected
Protected
Unprotected
Blocks
Protected
Writeable
Protected
Writeable
Protected
Writeable
Status
Register
Protected
Writeable
Protected
Protected
Protected
Writeable
Read Sequence (Read): Reading the AT25320B/640B via the Serial Output (SO) pin requires the following sequence.
After the CS line is pulled low to select a device, the Read opcode is transmitted via the SI line followed by the byte
address to be read (A15–A0, see Table 5-6). Upon completion, any data on the SI line will be ignored. The data (D7–D0)
at the specified address is then shifted out onto the SO line. If only one byte is to be read, the CS line should be driven
high after the data comes out. The read sequence can be continued since the byte address is automatically incremented
and data will continue to be shifted out. When the highest address is reached, the address counter will roll over to the
lowest address allowing the entire memory to be read in one continuous read cycle.
Atmel AT25320B/640B [DATASHEET]
9
8535G–SEEPROM–11/2012
Share Link: 