AT28HC64BF データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

AT28HC64BF

64K (8K x 8) High Speed Parallel EEPROM with Page Write and Software Data Protection

Atmel Corporation 

3. Block Diagram

AT28HC64BF

VCC

GND

OE

WE

CE

ADDRESS

INPUTS

OE, CE and WE

LOGIC

Y DECODER

X DECODER

DATA INPUTS/OUTPUTS

I/O0 - I/O7

DATA LATCH

INPUT/OUTPUT

BUFFERS

Y-GATING

CELL MATRIX

IDENTIFICATION

4. Device Operation

4.1 Read

The AT28HC64BF is accessed like a Static RAM. When CE and OE are low and WE is high,

the data stored at the memory location determined by the address pins is asserted on the out-

puts. The outputs are put in the high-impedance state when either CE or OE is high. This dual

line control gives designers flexibility in preventing bus contention in their systems.

4.2 Byte Write

4.3 Page Write

A low pulse on the WE or CE input with CE or WE low (respectively) and OE high initiates a

write cycle. The address is latched on the falling edge of CE or WE, whichever occurs last.

The data is latched by the first rising edge of CE or WE. Once a byte write has been started, it

will automatically time itself to completion. Once a programming operation has been initiated

and for the duration of tWC, a read operation will effectively be a polling operation.

The page write operation of the AT28HC64BF allows 1 to 64 bytes of data to be written into

the device during a single internal programming period. A page write operation is initiated in

the same manner as a byte write; after the first byte is written, it can then be followed by 1 to

63 additional bytes. Each successive byte must be loaded within 150 µs (tBLC) of the previous

byte. If the tBLC limit is exceeded, the AT28HC64BF will cease accepting data and commence

the internal programming operation. All bytes during a page write operation must reside on the

same page as defined by the state of the A6 to A12 inputs. For each WE high-to-low transition

during the page write operation, A6 to A12 must be the same.

The A0 to A5 inputs specify which bytes within the page are to be written. The bytes may be

loaded in any order and may be altered within the same load period. Only bytes which are

specified for writing will be written; unnecessary cycling of other bytes within the page does

not occur.

4.4 DATA Polling

The AT28HC64BF features DATA Polling to indicate the end of a write cycle. During a byte or

page write cycle, an attempted read of the last byte written will result in the complement of the

written data to be presented on I/O7. Once the write cycle has been completed, true data is

valid on all outputs, and the next write cycle may begin. DATA Polling may begin at any time

during the write cycle.

3

3648A–PEEPR–10/06

Share Link: