ATA6616(2012) データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

ATA6616
(Rev.:2012)

8K/16K Flash Microcontroller with LIN Transceiver, 5V Regulator and Watchdog

Atmel Corporation 

3.4.2

Silent Mode

A falling edge at EN when TXD is high switches the IC into Silent Mode. The TXD Signal has

to be logic high during the Mode Select window (see Figure 3-3 on page 10). The transmission

path is disabled in Silent Mode. The overall supply current from VBatt is a combination of the

IVSsi = 57µA plus the VCC regulator output current IVCC.

The internal slave termination between the LIN pin and the VS pin is disabled in Silent Mode.

Only a weak pull-up current (typically 10µA) between the LIN pin and the VS pin is present.

Silent Mode can be activated independently from the actual level on the LIN, WAKE, or KL_15

pins. If an undervoltage condition occurs, NRES is switched to low, and the IC changes its

state to Fail-safe Mode.

A voltage lower than the LIN Pre_Wake detection VLINL at the LIN pin activates the internal

LIN receiver and switches on the internal slave termination between the LIN pin and the VS

pin.

Figure 3-3. Switch to Silent Mode

Normal Mode

Silent Mode

EN

TXD

NRES

Mode select window

td = 3.2µs

VCC

Delay time silent mode

td_silent = maximum 20µs

LIN

LIN switches directly to recessive mode

A falling edge at the LIN pin followed by a dominant bus level maintained for a certain time

period (> tbus) and followed by a rising edge at the LIN pin (see Figure 3-4 on page 11) results

in a remote wake-up request. The device switches from Silent Mode to Fail-safe Mode. The

remote wake-up request is indicated by a low level at the RXD pin to interrupt the microcon-

troller (see Figure 3-4 on page 11). EN high can be used to switch directly to Normal Mode.

10 Atmel ATA6616/ATA6617

9132F–AUTO–02/12

Share Link: