ATA6628 データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

ATA6628

LIN Bus Transceiver with 3.3V (5V) Regulator and Watchdog

Atmel Corporation 

4.4 Sleep or Silent Mode: Behavior at a Floating LIN-bus or a Short Circuited LIN to GND

In Sleep or in Silent Mode the device has a very low current consumption even during short-circuits or floating conditions on

the bus. A floating bus can arise if the Master pull-up resistor is missing, e.g., if it is switched off when the LIN- Master is in

sleep mode or even if the power supply of the Master node is switched off.

In order to minimize the current consumption IVS in sleep or silent mode during voltage levels at the LIN-pin below the LIN

pre-wake threshold, the receiver is activated only for a specific time tmon. If tmon elapses while the voltage at the bus is lower

than Pre-wake detection low (VLINL) and higher than the LIN dominant level, the receiver is switched off again and the circuit

changes back to sleep respectively Silent Mode. The current consumption is then IVSsleep_short or IVSsilent_short (typ. 10µA more

than IVSsleep respectively IVSsilent). If a dominant state is reached on the bus no wake-up will occur. Even if the voltage rises

above the Pre-wake detection high (VLINH), the IC will stay in sleep respectively silent mode (see Figure 4-6).

This means the LIN-bus must be above the Pre-wake detection threshold VLINH for a few microseconds before a new LIN

wake-up is possible.

Figure 4-6. Floating LIN-bus during Sleep or Silent Mode

LIN BUS

VLINL

VBUSdom

LIN Pre-wake

LIN dominant state

IVS

IVSsleep/silent

tmon

IVSfail

IVSsleep_short /

IVSsilent_short

IVSsleep/silent

Mode of

operation Sleep/Silent Mode

Wake-up Detection Phase

Int. Pull-up

Resistor

RLIN

off (disabled)

Sleep/Silent Mode

12 ATA6628/ATA6630 [DATASHEET]

9117I–AUTO–10/14

Share Link: