ATTINY461-15MAZ データシートの表示（PDF） - Atmel Corporation

部品番号

コンポーネント説明

メーカー

ATTINY461-15MAZ

8-bit Microcontroller with 2/4/8K Bytes In-System Programmable Flash

Atmel Corporation 

ATtiny261/ATtiny461/ATtiny861

The ATtiny261/461/861 provides the following features: 2/4/8K byte of In-System Programmable

Flash, 128/256/512 bytes EEPROM, 128/256/512 bytes SRAM, 6 general purpose I/O lines, 32

general purpose working registers, one 8-bit Timer/Counter with compare modes, one 8-bit high

speed Timer/Counter, Universal Serial Interface, Internal and External Interrupts, a 4-channel,

10-bit ADC, a programmable Watchdog Timer with internal Oscillator, and three software select-

able power saving modes. The Idle mode stops the CPU while allowing the SRAM,

Timer/Counter, ADC, Analog Comparator, and Interrupt system to continue functioning. The

Power-down mode saves the register contents, disabling all chip functions until the next Inter-

rupt or Hardware Reset. The ADC Noise Reduction mode stops the CPU and all I/O modules

except ADC, to minimize switching noise during ADC conversions.

The device is manufactured using Atmel®’s high density non-volatile memory technology. The

On-chip ISP Flash allows the Program memory to be re-programmed In-System through an SPI

serial interface, by a conventional non-volatile memory programmer or by an On-chip boot code

running on the AVR core.

The ATtiny261/461/861 AVR is supported with a full suite of program and system development

tools including: C Compilers, Macro Assemblers, Program Debugger/Simulators, In-Circuit Emu-

lators, and Evaluation kits.

2.2 Pin Descriptions

2.2.1 VCC

Supply voltage.

2.2.2 GND

Ground.

2.2.3 AVCC

Analog supply voltage.

2.2.4 AGND

Analog ground.

2.2.5

Port A (PA7..PA0)

Port A is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The

Port A output buffers have symmetrical drive characteristics with both high sink and source

capability. As inputs, Port A pins that are externally pulled low will source current if the pull-up

resistors are activated. The Port A pins are tri-stated when a reset condition becomes active,

even if the clock is not running.

Port A also serves the functions of various special features of the ATtiny261/461/861 as listed

on page 66.

5

7753C–AVR–07/09

Share Link: