W91466N データシートの表示（PDF） - Winbond

部品番号

コンポーネント説明

メーカー

W91466N

3-MEMORY TONE/PULSE DIALER WITH SAVE FUNCTION

Winbond 

W91460N SERIES

OFF HOOK , D1 , D2 , ..., Dn , */T , D1' , D2' , ..., Dn'

1. If the mode switch is set to pulse mode, then the output signal will be:

D1, D2, …, Dn, Pause (3.6 sec.), D1', D2', …, Dn'

(Pulse)

(Tone )

2. If the mode switch is set to tone mode, then the output signal will be as follows:

D1, D2, ..., Dn, *, D1', D2', ..., Dn'

(Tone)

(Tone)

3. The dialer remains in tone mode when the digits have been dialed out and can be reset to pulse

mode only by going on-hook.

4. The pulse-to-tone function timing diagram is shown in Figure 4.

Flash

OFF HOOK , Fn

1. Fn = F1, …, F4

2. The dialer will execute a flash break time of 600 mS (F1), 300 mS (F2), 73 mS (F3), or 100 mS

(F4) In each case, the flash pause time is 1.0 sec. before the next digit is dialed out.

3. Flash key can be stored as a digit in memory; however, only one flash will be released to users.

4. The system will return to the initial state after the flash pause time is finished.

5. The timing diagram of flash function is shown in Figure 5.

Save

OFF HOOK , D1 , D2 , Dn , SAVE

...,

1. If the dialing

of

D1 to Dn is finished, pressing the

be copied to the save memory.

SAVE

key will cause D1 to Dn to

OFF HOOK , SAV

E

2. D1 to Dn will be dialed out after the save key is pressed.

Cascaded Dialing

1. Normal Dialing + Repertory Dialing + Normal Dialing

2. Repertory Dialing + Normal Dialing + Repertory Dialing

3. Redialing +

Normal

+ Repertory Dialing

-6-

Share Link: