DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

BH3541F-E2 データシートの表示(PDF) - ROHM Semiconductor

部品番号
コンポーネント説明
メーカー
BH3541F-E2
ROHM
ROHM Semiconductor ROHM
BH3541F-E2 Datasheet PDF : 9 Pages
1 2 3 4 5 6 7 8 9
BH3541F,BH3544F,BH3547F,BH3548F
Technical Note
4) GND potential
Make the GND pin voltage such that it is the lowest voltage even when operating below it. Actually confirm that the
voltage of each pin does not become a lower voltage than the GND pin, including transient phenomena.
5) Thermal design
Perform thermal design in which there are adequate margins by taking into account the allowable power dissipation in
actual states of use.
6) Shorts between pins and misinstallation
When mounting the LSI on a board, pay adequate attention to orientation and placement discrepancies of the LSI.
If it is misinstalled and the power is turned on, the LSI may be damaged. It also may be damaged if it is shorted by a
foreign substance coming between pins of the LSI or between a pin and a power supply or a pin and a GND.
7) Operation in strong magnetic fields
Adequately evaluate use in a strong magnetic field, since there is a possibility of malfunction.
8) Pop noise countermeasures
In order to prevent the pop noise that occurs when the power supply turns ON or OFF, make the rise and fall with
reference to the timing diagram shown below.
1)BH3541F/ BH3544F/ BH3548F
Rise time
A
PLAY period
Rise time
A
VCC
B
C
OUT
MUTE
Fig. 16
(A):Mute period (Use as pop noise countermeasure when power supply turns ON/OFF by makingVMUTE=Lo.)
(B):Mute cancellation period (This has a time constant because it is used by the externally attached C2 and R2 as
a pop noise countermeasure on mute cancellation, so be careful of the timing.)
(C):Mute start time (As on cancellation, this has a time constant.)
2)BH3547F
(Rise time)
(PLAY period)
(MUTE period)
(Fall period)
VCC
(B)
(A)
Vmute
SG
(Input Signal)
OUT
Fig. 17
(A):Before VCC rise (or at the same time as VCC) make mute cancelled (VMUTE=Hi).
(B):Soft mute period (This time can be set by externally attached R2 and C2)
www.rohm.com
© 2010 ROHM Co., Ltd. All rights reserved.
7/8
2010.05 - Rev.A

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]