CS5371A データシートの表示（PDF） - Cirrus Logic
部品番号
コンポーネント説明
メーカー
CS5371A Datasheet PDF : 32 Pages
| |||
CS5371A CS5372A
1. CHARACTERISTICS AND SPECIFICATIONS
• Min / Max characteristics and specifications are guaranteed over the Specified Operating Conditions.
• Typical performance characteristics and specifications are measured at nominal supply voltages and TA = 25°C.
• GND = 0 V. Single-ended voltages with respect to GND, differential voltages with respect to opposite half.
• Device is connected as shown in Figure 9 on page 14 unless otherwise noted.
SPECIFIED OPERATING CONDITIONS
Parameter
Bipolar Power Supplies
Positive Analog
Negative Analog
Positive Digital
Voltage Reference
[VREF+] - [VREF-]
VREF-
Thermal
Ambient Operating Temperature
Symbol Min
Nom
Max Unit
± 2% VA+
2.45
2.50
2.55
V
(Note 1) ± 2% VA-
-2.45 -2.50 -2.55
V
± 3% VD
3.20
3.30
3.40
V
(Note 2, 3) VREF
-
2.500
-
V
(Note 4) VREF-
-
VA -
-
V
Industrial (-ISZ) TA
-40
25
85
°C
Notes: 1. VA- must always be the most-negative input voltage to avoid potential SCR latch-up conditions.
2. By design, a 2.500 V voltage reference input results in the best signal-to-noise performance.
3. Channel-to-channel gain accuracy is directly proportional to the voltage reference absolute accuracy.
4. VREF inputs must satisfy: VA- ≤ VREF- < VREF+ ≤ VA+.
ABSOLUTE MAXIMUM RATINGS
Parameter
DC Power Supplies
Positive Analog
Negative Analog
Digital
Analog Supply Differential
(VA+) - (VA-)
Digital Supply Differential
(VD) - (VA-)
Input Current, Power Supplies
(Note 5)
Input Current, Any Pin Except Supplies
(Note 5, 6)
Output Current
(Note 5)
Power Dissipation
Analog Input Voltages
Digital Input Voltages
Storage Temperature Range
Symbol
VA+
VA-
VD
VADIFF
VDDIFF
IPWR
IIN
IOUT
PDN
VINA
VIND
TSTG
Min
-0.5
-6.8
-0.5
-
-
-
-
-
-
(VA-) - 0.5
-0.5
-65
Max
6.8
0.5
6.8
6.8
6.8
±50
±10
±25
500
(VA+) + 0.5
(VD) + 0.5
150
Parameter
V
V
V
V
V
mA
mA
mA
mW
V
V
ºC
WARNING: Operation at or beyond these limits may result in permanent damage to the device.
Normal operation is not guaranteed at these extremes.
Notes: 5. Transient currents up to ±100 mA will not cause SCR latch-up.
6. Includes continuous over-voltage conditions at the modulator analog input pins.
4
DS748F2
Share Link: 