EL5128(2004) データシートの表示（PDF） - Intersil
部品番号
コンポーネント説明
メーカー
EL5128 Datasheet PDF : 11 Pages
| |||
EL5128
Absolute Maximum Ratings (TA = 25°C)
Supply Voltage between VS+ and VS- . . . . . . . . . . . . . . . . . . . .+18V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . VS- - 0.5V, VS + 0.5V
Maximum Continuous Output Current . . . . . . . . . . . . . . . . . . 30mA
Maximum Die Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . +125°C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . .-65°C to +150°C
Ambient Operating Temperature . . . . . . . . . . . . . . . .-40°C to +85°C
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Curves
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typ values are for information purposes only. Unless otherwise noted, all tests are at
the specified temperature and are pulsed tests, therefore: TJ = TC = TA
Electrical Specifications VS+ = +5V, VS- = -5V, RL = 10kΩ and CL = 10pF to 0V, TA = 25°C unless otherwise specified
PARAMETER
DESCRIPTION
CONDITION
MIN TYP MAX
UNIT
INPUT CHARACTERISTICS
VOS
TCVOS
IB
RIN
CIN
CMIR
Input Offset Voltage
Average Offset Voltage Drift
Input Bias Current
Input Impedance
Input Capacitance
Common-Mode Input Range
CMRR
Common-Mode Rejection Ratio
AVOL
AV
Open-Loop Gain
Voltage Gain
OUTPUT CHARACTERISTICS
VCM = 0V
(Note 1)
VCM = 0V
(VCOM amps)
(VCOM amps) for VIN from -5.5V to +5.5V
-4.5V ≤ VOUT ≤ +4.5V (VCOM amps)
-4.5V ≤ VOUT ≤ +4.5V
-5.5
50
75
0.995
2
5
2
1
1.35
70
95
12
50
+5.5
1.005
mV
µV/°C
nA
GΩ
pF
V
dB
dB
V/V
VOL
Output Swing Low
VOH
Output Swing High
ISC
Short Circuit Current
IOUT
Output Current
POWER SUPPLY PERFORMANCE
IL = -5mA
IL = 5mA
-4.92 -4.85
V
4.85 4.92
V
±120
mA
±30
mA
PSRR
Power Supply Rejection Ratio
IS
Supply Current (per amplifier)
DYNAMIC PERFORMANCE
VS is moved from ±2.25V to ±7.75V
No load
60
80
dB
660 1000
µA
SR
tS
BW
GBWP
PM
CS
Slew Rate (Note 2)
Settling to +0.1% (AV = +1)
-3dB Bandwidth
Gain-Bandwidth Product
Phase Margin
Channel Separation
-4.0V ≤ VOUT ≤ +4.0V, 20% to 80%
(AV = +1), VO = 2V step
RL = 10kΩ, CL = 10pF
RL = 10kΩ, CL = 10pF (VCOM amps)
RL = 10kΩ, CL = 10pF (VCOM amps)
f = 5MHz
10
V/µs
500
ns
12
MHz
8
MHz
50
°
75
dB
NOTES:
1. Measured over operating temperature range.
2. Slew rate is measured on rising and falling edges.
2
Share Link: 