ELM334 データシートの表示（PDF） - Elm Electronics
部品番号
コンポーネント説明
メーカー
ELM334 Datasheet PDF : 7 Pages
| |||
ELM334
Absolute Maximum Ratings
Storage Temperature....................... -65°C to +150°C
Ambient Temperature with
Power Applied....................................-40°C to +85°C
Voltage on VDD with respect to VSS............ 0 to +7.5V
Voltage on any other pin with
respect to VSS........................... -0.6V to (VDD + 0.6V)
Note:
Stresses beyond those listed here will likely damage
the device. These values are given as a design
guideline only. The ability to operate to these levels
is neither inferred nor recommended.
Electrical Characteristics
All values are for operation at 25°C and a 5V supply, unless otherwise noted. For further information, refer to note 1 below.
Characteristic
Minimum Typical Maximum Units
Conditions
Supply Voltage, VDD
3.0
5.0
VDD rate of rise
0.05
Average Supply Current, IDD
1.0
Debounce Period
Pushbutton
26
Position Switches
512
Control Output Pulse Width
512
Internal Pullup Resistance
400
20
Typical Output Voltages
(pins 2, 3, or 5)
4.5
5.5
V
V/ms see note 2
2.4
mA VDD = 5V, see note 3
msec pickup or dropout times
msec
msec see note 4
KΩ pin 4
KΩ pin 6 or 7
0.5
V Current (sink) = 15 mA
V Current (source) = 7.0 mA
Notes:
1. This integrated circuit is produced with a Microchip Technology Inc.’s PIC12C5XX as the core embedded
microcontroller. For further device specifications, and possibly clarification of those given, please refer to the
appropriate Microchip documentation ( http://www.microchip.com/ ).
2. This spec must be met in order to ensure that a correct power on reset occurs. It is quite easily achieved
using most common types of supplies, but may be violated if one uses a slowly varying supply voltage, as
may be obtained through direct connection to solar cells, or some charge pump circuits.
3. Integrated circuit only. Does not include any LED or drive currents.
4. This is the pin 5 output pulse width, once triggered by an active input on pin 4. The duration of the pulse
does not change if the pushbutton is released before this time passes, or if is held for much longer times.
ELM334DSC
Elm Electronics – Circuits for the Hobbyist
< http://www.elmelectronics.com/ >
3 of 7
Share Link: 