EN25P20 データシートの表示（PDF） - Eon Silicon Solution Inc.

部品番号

コンポーネント説明

メーカー

EN25P20

2 Mbit Uniform Sector, Serial Flash Memory

Eon Silicon Solution Inc. 

EN25P20

Write Enable (WREN) (06h)

The Write Enable (WREN) instruction (Figure 5) sets the Write Enable Latch (WEL) bit. The Write Enable

Latch (WEL) bit must be set prior to every Page Program (PP), Sector Erase (SE), Bulk Erase (BE) and

Write Status Register (WRSR) instruction.

The Write Enable (WREN) instruction is entered by driving Chip Select (CS#) Low, sending the instruction

code, and then driving Chip Select (CS#) High.

Write Disable (WRDI) (04h)

The Write Disable instruction (Figure 6) resets the Write Enable Latch (WEL) bit in the Status Register to

a 0. The Write Disable instruction is entered by driving Chip Select (CS#) low, shifting the instruction code

“04h” into the DI pin and then driving Chip Select (CS#) high. Note that the WEL bit is automatically reset

after Power-up and upon completion of the Write Status Register, Page Program, Sector Erase, and Bulk

Erase instructions.

This Data Sheet may be revised by subsequent versions

9

or modifications due to changes in technical specifications.

©2004 Eon Silicon Solution, Inc., www.essi.com.tw

Rev. D, Issue Date: 2007/05/07

Share Link: