DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

M50LPW040 データシートの表示(PDF) - STMicroelectronics

部品番号
コンポーネント説明
メーカー
M50LPW040 Datasheet PDF : 36 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
M50LPW040
current PC Chipsets; the M50LPW040 acts as the
PC BIOS on the Low Pin Count bus for these PC
Chipsets.
The secondary interface, the Address/Address
Multiplexed (or A/A Mux) Interface, is designed to
be compatible with current Flash Programmers for
production line programming prior to fitting to a PC
Motherboard.
The memory is offered in TSOP40 (10 x 20mm)
and PLCC32 packages and it is supplied with all
the bits erased (set to ’1’).
SIGNAL DESCRIPTIONS
There are two different bus interfaces available on
this part. The active interface is selected before
power-up or during Reset using the Interface Con-
figuration Pin, IC.
The signals for each interface are discussed in the
Low Pin Count (LPC) Signal Descriptions section
and the Address/Address Multiplexed (A/A Mux)
Signal Descriptions section below. The supply sig-
nals are discussed in the Supply Signal Descrip-
tions section below.
Figure 4. PLCC Connections
Table 1. Signal Names (LPC Interface) Memory
LAD0-LAD3
Input/Output Communications
LFRAME
Input Communication Frame
ID0-ID2
Identification Inputs
GPI0-GPI4
General Purpose Inputs
IC
Interface Configuration
RP
Interface Reset
INIT
CPU Reset
CLK
Clock
TBL
Top Block Lock
WP
Write Protect
RFU1
Reserved for Future Use. Leave
disconnected
VCC
Supply Voltage
VPP
Optional Supply Voltage for Fast
Erase Operations
VSS
Ground
NC
Not Connected Internally
Note: 1. Pin 9 in the PLCC32, and Pin 21 in the TSOP40, may also
be driven High or driven Low.
A/A Mux
A/A Mux
A7
A6
A5
A4
A3
A2
A1
A0
DQ0
GPI1
GPI0
WP
TBL
RFU 9
ID2
ID1
ID0
LAD0
1 32
M50LPW040
17
IC (VIL)
NC
NC
VSS
25 VCC
INIT
LFRAME
RFU
RFU
IC (VIH)
NC
NC
VSS
VCC
G
W
RB
DQ7
A/A Mux
Note: Pins 27 and 28 are not internally connected.
A/A Mux
AI05438
3/36

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]