HIP0080AM(1998) データシートの表示（PDF） - Intersil
部品番号
コンポーネント説明
メーカー
HIP0080AM Datasheet PDF : 15 Pages
| |||
HIP0080, HIP0081
Absolute Maximum Ratings
Thermal Information
Supply Voltage (Logic and Control), VCC . . . . . . . . . . . . -16 to 45V
Power MOSFET Drain Voltage, VO (Note 1) . . . . . . -0.5 to VCLAMP
Maximum Output Clamp Energy, EOK (HIP0080) . . . . . . . . . Note 4
Maximum Output Clamp Energy, EOK (HIP0081) . . . . . . . . . Note 4
Input Voltage (Logic and Driver Inputs), VIN . . . . . . . . . . . -0.5 to 7V
Output Voltage, DATAOUT . . . . . . . . . . . . . . . . . . . . . . . . -0.5 to 7V
HIP0080 Output Current
Each Output, IOUT(PEAK), (Note 2) . . . . . . -1.5A to IOUT(SC)
Each Output, IOUT(DC) . . . . . . . . . . . . . . . . . . . . . . . . +1.3A
Total of 4 Outputs ON, Unequal IOUT . . . . . . . . . . . . . . . . +3A
Total of 4 Outputs ON, Unequal IOUT . . . . . +4A/500ms (Max)
HIP0081 Output Current
Each Output, IOUT(PEAK), (Note 2) . . . . . . . . . -2 to IOUT(SC)
Each Output, IOUT(DC) . . . . . . . . . . . . . . . . . . . . . . . . +2.2A
Total of 4 Outputs, ON, Unequal IOUT . . . . . . . . . . . . . . . +6A
Total of 4 Outputs ON, Unequal IOUT . . . . . +8A/500ms (Max)
Operating Conditions
Ambient Temperature Range . . . . . . . . . . . . . . . . . -40oC to 125oC
Junction Temperature Range . . . . . . . . . . . . . . . . . -40oC to 150oC
Thermal Resistance (Typical, Note 3)
θJA(oC/W) θJC(oC/W)
HIP0080 . . . . . . . . . . . . . . . . . . . . . . . .
43
N/A
HIP0080 (on 2 sq. in. PC Board) . . . . .
33
N/A
HIP0081 . . . . . . . . . . . . . . . . . . . . . . . .
45
3
HIP0080 Power Dissipation with a 2 sq. in. PC board heat sink:
At 85oC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.95W
Above 85oC:. . . . . . . . . . . . . . . . . . . Derate Linearly at 30mW/oC
HIP0081 Power Dissipation with infinite heat sink:
At 125oC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.33W
Above 125oC . . . . . . . . . . . . . . . . . Derate Linearly at 333 mW/oC
Maximum
Maximum
Storage Temperature Range,
Lead Temperature (Soldering
TSTG
10s)
.
.
.
.
.
.
.
.
-55oC to
.......
150oC
300oC
Die Characteristics
HIP0080 Back Side Potential . . . . . . . . . . . . . . Frame, GND Leads
HIP0081 Back Side Potential . . . . . . . . . Heat Sink Tab, GND Lead
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. The MOSFET Output Drain is internally Clamped with a Drain-to-Gate zener diode that turns-on the MOSFET to hold the Drain at the VCLAMP
voltage. Refer to the Electrical Characteristic Tables for the VCLAMP voltage limits.
2. Each Output has Over-Current Shutdown protection in the positive current direction. The maximum peak current rating is determined by the
minimum Over-Current Shutdown as detailed in the Electrical Specification Table. In the event of an Over-Current Shutdown the input drive is
latched OFF. The output short must be removed and the input toggled OFF and ON to restore the output drive.
3. Effective Heat Sinking for the HIP0080 PLCC package requires a PC Board solder mount or equivalent. The HIP0080 θJA junction-to-air thermal
resistance is given for a PC Board with 2 sq. in. of 1 oz. surface mount ground copper extending away from the package. For additional Power
Dissipation Derating information, see Figure 8 curves.
4. Refer to Figures 4 and 5 Single Pulse Output Clamp Energy vs. Time Capability of the HIP0080 and HIP0081. The safe margin for single pulse
energy operation is below the dotted line shown in Figures 4 and 5.
Electrical Specifications VCC = 5.5V to 25V ±5%, TA = -40oC to 125oC, Unless Otherwise Specified
HIP0080
HIP0081
PARAMETER
SYMBOL
TEST CONDITIONS
MIN TYP MAX MIN TYP MAX UNITS
POWER OUTPUTS
Output ON Resistance
(HIP0081)
Output ON Resistance
(HIP0080)
HIP0081 Output Off Current
HIP0081 Output Leakage
Current
HIP0080 Output Off
Current
rON
rON
IOFF
IOFFLK
IOFF
VCC = 10 to 25V, All Outputs ON
IOUT1 = IOUT2 = IOUT3 = IOUT4 = 1A
VCC = 5.5 to 10V, All Outputs ON
IOUT1 = IOUT2 = IOUT3 = IOUT4 = 0.7A
VCC = 10 to 25V, All Outputs ON
IOUT1 = IOUT2 = IOUT3 = IOUT4 = 0.5A
VCC = 5.5 to 10V, All Outputs ON
IOUT1 = IOUT2 = IOUT3 = IOUT4 = 0.4A
ITnApu=ts25LooCw,toEa1c2h5oVCOUT = 60V
Inputs Low,
TA = -40oC
Each
VOUT
=
60V,
Inputs Low, Each VOUT = 60V,
VCC = 0V
IEnNpAutBsLLEowH,igEha,cThAV=O2U5ToC=
25V,
to 125oC
IEnNpAutBsLLEowH,igEha,cThAV=O-U40To=C25V,
-
-
-
-
-
0.5
Ω
-
-
-
-
-
1.0
Ω
-
-
1.0 -
-
-
Ω
-
-
2.0 -
-
-
Ω
-
-
-
-
0.75 1.0 mA
-
-
-
-
0.75 1.5 mA
-
-
-
-
1.0
10
µA
-
0.75 1.0
-
-
-
mA
-
0.75 1.5
-
-
-
mA
4
Share Link: 