HT6P12
(when the AUTO_ARM delay time is not
zero), the disarm state will change to the arm
state after the AUTO_ARM delay time (de-
fined by the “AUTO_ARM delay time” in the
option table). The timing of the alarm trigger
is shown below.
Panic mode
Whether in the arm or disarm state, after a
panic control signal has been received, the siren
will sound and the car lamp will flash. The
timing of the SIREN, FLASH, and LED outputs
is the same as the timing of the alarm trigger
mode. The active output length is on a par with
the TRIG siren active time, One interval (de-
fined by the “TRIG and Panic siren active time”
in the option taable). The siren sound as well as
the car lamp flash can be interrupted by occur-
rence of a second panic control signal or by
activating the ACC (DI) pin. The panic mode
takes a priority of other modes.
Alarm Triggers (AL+, AL-, TRIG) for Arm State
Note: During the Entry delay time, the chip ignores all trigger signals from the TRIG, AL+, AL- pins.
11
2nd Oct ’97