HT82K94E_07 データシートの表示（PDF） - Holtek Semiconductor
部品番号
コンポーネント説明
メーカー
HT82K94E_07 Datasheet PDF : 43 Pages
| |||
HT82K94E/HT82K94A
Functional Description
Execution Flow
The system clock for the microcontroller is derived from
a crystal (6 or 12MHz). The system clock is internally di-
vided into four non-overlapping clocks. One instruction
cycle consists of four system clock cycles.
Instruction fetching and execution are pipelined in such
a way that a fetch takes an instruction cycle while de-
coding and execution takes the next instruction cycle.
However, the pipelining scheme allows each instruction
to be effectively executed in a cycle. If an instruction
changes the program counter, two cycles are required to
complete the instruction.
Program Counter - PC
The program counter (PC) controls the sequence in
which the instructions stored in the program ROM are
executed and its contents specify a full range of pro-
gram memory.
After accessing a program memory word to fetch an in-
struction code, the contents of the program counter are
incremented by one. The program counter then points to
the memory word containing the next instruction code.
When executing a jump instruction, conditional skip ex-
ecution, loading PCL register, subroutine call or return
from subroutine, initial reset, internal interrupt, USB in-
terrupt or return from interrupts, the PC manipulates the
program transfer by loading the address corresponding
to each instruction.
The conditional skip is activated by instructions. Once
the condition is met, the next instruction, fetched during
the current instruction execution, is discarded and a
dummy cycle replaces it to get the proper instruction.
Otherwise proceed to the next instruction.
The lower byte of the program counter (PCL) is a read-
able and writeable register (06H). Moving data into the
PCL performs a short jump. The destination will be
within the current program ROM page.
When a control transfer takes place, an additional
dummy cycle is required.
T1 T2 T3 T4 T1 T2 T3 T4 T1 T2 T3 T4
S y s te m C lo c k
O S C 2 ( R C o n ly )
PC
PC
PC +1
PC +2
F e tc h IN S T (P C )
E x e c u te IN S T (P C -1 )
F e tc h IN S T (P C + 1 )
E x e c u te IN S T (P C )
Execution Flow
F e tc h IN S T (P C + 2 )
E x e c u te IN S T (P C + 1 )
Mode
*12 *11 *10 *9
Initial Reset
0000
USB Interrupt
0000
Timer/Event Counter 0 Overflow 0 0 0 0
Timer/Event Counter 1 Overflow 0 0 0 0
Skip
Loading PCL
*12 *11 *10 *9
Jump, Call Branch
#12 #11 #10 #9
Return from Subroutine
S12 S11 S10 S9
Program Counter
*8 *7 *6 *5 *4 *3 *2 *1 *0
000000000
000000100
000001000
000001100
Program Counter+2
*8 @7 @6 @5 @4 @3 @2 @1 @0
#8 #7 #6 #5 #4 #3 #2 #1 #0
S8 S7 S6 S5 S4 S3 S2 S1 S0
Note: *12~*0: Program counter bits
#12~#0: Instruction code bits
Program Counter
S12~S0: Stack register bits
@7~@0: PCL bits
Rev. 1.50
6
October 11, 2007
Share Link: 