HV857L(2013) データシートの表示（PDF） - Supertex Inc
部品番号
コンポーネント説明
メーカー
HV857L Datasheet PDF : 8 Pages
| |||
HV857L
External
Component
Diode
Description
Fast reverse recovery diode, BAS21 diode or equivalent.
CS Capacitor
0.003µF to 0.1µF, 100V capacitor to GND is used to store the energy transferred from the inductor.
The EL lamp frequency is controlled via an external REL resistor connected between REL-Osc and VDD
of the device. The lamp frequency increases as REL decreases. As the EL lamp frequency increases,
the amount of current drawn from the battery will increase and the output voltage VCS will decrease. The
color of the EL lamp is dependent upon its frequency.
REL Resistor
A 2MΩ resistor would provide lamp frequency of 205Hz. Decreasing the REL resistor by a factor of 2 will
increase the lamp frequency by a factor of 2.
(2MΩ)(205Hz)
fEL =
REL
RSW Resistor
The switching frequency of the converter is controlled via an external resistor, RSW, between RSW-Osc
and VDD of the device. The switching frequency increases as RSW decreases. With a given inductor, as
the switching frequency increases, the amount of current drawn from the battery will decrease and the
output voltage, VCS, will also decrease.
(560kΩ)(77Hz)
fSW =
RSW
LX Inductor
Lamp
The inductor LX is used to boost the low input voltage by inductive flyback. When the internal switch is
on, the inductor is being charged. When the internal switch is off, the charge stored in the inductor will
be transferred to the high voltage capacitor CS. The energy stored in the capacitor is connected to the
internal H-bridge, and therefore to the EL lamp. In general, smaller value inductors, which can handle
more current, are more suitable to drive larger size lamps. As the inductor value decreases, the switch-
ing frequency of the inductor (controlled by RSW) should be increased to avoid saturation.
A 220µH Murata (LQH32CN221) inductor with 8.4Ω series DC resistance is typically recommended.
For inductors with the same inductance value, but with lower series DC resistance, a lower RSW resistor
value is needed to prevent high current draw and inductor saturation.
As the EL lamp size increases, more current will be drawn from the battery to maintain high voltage
across the EL lamp. The input power, (VIN x IIN), will also increase. If the input power is greater than
the power dissipation of the package, an external resistor in series with one side of the lamp is recom-
mended to help reduce the package power dissipation.
Doc.# DSFP-HV857L
A062013
Supertex inc.
6
www.supertex.com
Share Link: 