ICS1893AF(2002) データシートの表示（PDF） - Integrated Circuit Systems

部品番号

コンポーネント説明

メーカー

ICS1893AF
(Rev.:2002)

3.3V 10Base-T/100Base-TX Integrated PHYceiver™

Integrated Circuit Systems 

Integrated

Circuit

Systems, Inc.

ICS1893AF

Product Brief

3.3V 10Base-T/100Base-TX Integrated PHYceiver™

General

The ICS1893AF is a lower cost, re-packaged version of

the ICS1893Y-10. The ICS1893AF is a fully integrated,

Physical Layer device (PHY) that is compliant with both

the 10Base-T and 100Base-TX CSMA/CD Ethernet

Standard, ISO/IEC 8802-3. The ICS1893AF uses the

same proven silicon as the ICS1893Y-10 but offers a

lower cost solution by using a lower cost 300mil 48-lead

SSOP package.

All parametric specifications and timing diagrams for the

ICS1893Y-10 apply to the ICS1893AF. Refer to the

1893 Data Sheet for detailed specifications and timings.

The ICS1893AF uses the same twisted-pair transmit and

receive circuits as the ICS1893Y-10, and the same

recommended board layout techniques apply to the

ICS1893AF.

The ICS1893AF is intended for Node applications using

the standard MII interface to the MAC.

All changes are listed in the ICS1893AF / ICS1893Y-10

Feature Set Comparison Table on page 2.

• DSP-based baseline wander correction to virtually

eliminate killer packets across temperature range of

-5º to +85º C.

• Low-power, 0.35-micron CMOS (typically 400mW)

• Single-chip, fully integrated PHY provides PCS, PMA,

PMD and AUTONEG Sublayers of the IEEE Std.

• 10Base-T and 100Base-TX IEEE 8802-3 compliant

• Clock or crystal supported.

• Media Independent Interface (MII) supported.

• Managed or Unmanaged Applications

• 10M or 100M Half and Full Duplex Modes

• Auto-Negotiation with Next Page. Parallel detection

for Legacy products.

• Fully-integrated, DSP-based PMD includes:

- Adaptive equalization and baseline wander correction

- Transmit wave shaping and stream cipher scrambler

- MLT-3 encoder and NRZ/NRZI encoder

• Highly configurable supports:

- Node applications, managed or unmanaged

- 10M or 100M half and full duplex modes

ICS1893AF Features

• Single 3.3V power supply

• Supports category 5 cables with attenuation in excess

of 24dB at 100 MHz across a temperature range from -

5º to +85º C.

• Loopback mode for Diagnostic Functions

• Small footprint 48-lead 300mil SSOP package.

10/100 MII

MAC

Interface

MII

Management

Interface

Interface

Mux

MII

Extended

Register

Set

PCS

• Framer

• CRS/COL Detection

• Parallel to Serial

• 4B/5B

100Base-TX

PMA

• Clock Recovery

• Link Monitor

• Signal Detection

• Error Detection

TP_PMD

• MLT-3

• Stream Cipher

• Adaptive Equalizer

• Base Line Wander

• Correction

Low

Jitter

Clock

Synthesizer

10Base-T

Configuration

and

Status

Integrated

Switch

Auto-

Negotiation

Clock

Power

ICS1893 Block Diagram

LEDs &

PHY Address

Document Revision: 5 April 2002

Twisted Pair

Interface to

Magnetics

Modules &

RJ45

Connector

Page 1

Share Link: