DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

307G-03LF データシートの表示(PDF) - Integrated Circuit Systems

部品番号
コンポーネント説明
メーカー
307G-03LF
ICST
Integrated Circuit Systems ICST
307G-03LF Datasheet PDF : 12 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
ICS307-03
SERIALLY PROGRAMMABLE CLOCK SOURCE
Absolute Maximum Ratings
Stresses above the ratings listed below can cause permanent damage to the ICS307-03. These ratings,
which are standard values for ICS commercially rated parts, are stress ratings only. Functional operation of
the device at these or any other conditions above those indicated in the operational sections of the
specifications is not implied.
Exposure to absolute maximum rating conditions for extended periods can affect product reliability.
Electrical parameters are guaranteed only over the recommended operating temperature range.
Supply Voltage, VDD
All Inputs and Outputs
Storage Temperature
Soldering Temperature
Item
Rating
5V
-0.5 V to VDD+0.5 V
-65 to +150°C
260°C
Recommended Operating Conditions
Parameter
Ambient Operating Temperature
Power Supply Voltage (measured in respect to GND)
Min.
0
+3.0
Typ.
Max.
+70
+3.6
Units
°C
V
DC Electrical Characteristics
VDD=3.3 V ±5% , Ambient temperature 0 to +70°C, unless stated otherwise
Parameter
Symbol
Conditions
Min. Typ.
Operating Voltage
VDD
3.0
Input High Voltage
Input Low Voltage
Output High Voltage
Output Low Voltage
Output High Voltage,
CMOS level
VIH
VIL
VOH
VOL
VOH
IOH = -4 mA
IOL = 4 mA
IOH = -6.5 mA
2
2.4
VDD-0.4
Tri-state Output Leakage
1
Max.
3.6
0.8
0.4
Units
V
V
V
V
V
V
µA
Operating Supply Current IDD 27 MHz crystal
24
mA
No load, 100 MHz out,
all outputs enabled
Short Circuit Current
CLK outputs
±60
mA
Input Capacitance
CIN
On-Chip Pull-up Resistor
RPU
On-Chip Pull-down
RPD
Resistor
4
pF
240
k
100
k
MDS 307-03 C
10
Revision 101705
Integrated Circuit Systems 525 Race Street, San Jose, CA 95126 tel (408) 297-1201 www.icst.com

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]