IN24LC02B データシートの表示（PDF） - Integral Corp.

部品番号

コンポーネント説明

メーカー

IN24LC02B

2K 2.5V CMOS Serial EEPROMs

Integral Corp. 

IN24LC02B

6.0 ACKNOWLEDGE POLLING

Since the device will not acknowledge during a write cycle, this can be used to determine when the

cycle is complete (this feature can be used to maximize bus throughput). Once

the stop condition for a write command has been

issued from the master, the device initiates the

Figure 7. Acknowledge Polling Flow

internally timed write cycle, ACK polling can be

initiated immediately. This involves the master

sending a start condition followed by the control

byte for a write command (R/W =0). If the

device is still busy with the write cycle, then no

ACK will be returned. If the cycle is complete,

then the device will return the ACK and the

master can then proceed with the next read or

write command. See Figure 7 for flow diagram.

WRITE PROTECTION

The IN24LC02B can be used as a serial ROM

when the WP pin is connected to Vcc.

Programming will be inhibited and the entire

memory will be write-protected.

READ OPERATION

Read operations are initiated in the same way as

write operations with the exception that the R/W

bit of the slave address is set to one. There are

three basic types of read operations: current

address read, random read, and sequential read.

Current Address Read

The IN24LC02B contains an address counter that maintains the address of the last word accessed,

internally incremented by one. Therefore, if the previous access (either a read or write operation)

was to address n, the next current address read operation would access data from address n + 1.

Upon receipt of the slave address with R/W bit set to one, the IN24LC04/08 issues an acknowledge

and transmits the eight bit data word. The master will not acknowledge the transfer but does

generate a stop condition and the IN24LC02B discontinues transmission (see Figure 9).

Random Read

Random read operations allow the master to access any memory location in a random manner. To

perform this type of read operation, first the word address must be set. This is done by sending the

word address to the IN24LC02B as part of a write operation. After the word address is sent, the

master generates a start condition following the acknowledge. This terminates the write operation,

but not before the internal address pointer is set. Then the master issues the control byte again but

with the R/W bit set to a one. The IN24LC02B will then issue an acknowledge and transmits the

eight bit data word. The master will not acknowledge the transfer but does generate a stop condition

and the IN24LC02B discontinues transmission (see Figure 10).

7

Share Link: