IRM-36XXG3 データシートの表示（PDF） - EVERLIGHT
部品番号
コンポーネント説明
メーカー
IRM-36XXG3 Datasheet PDF : 12 Pages
| |||
Infrared Remote Control
Receiver Module
IRM-36XXG3 Series
Test Method：
The specified electro-optical characteristics is satisfied under the following
conditions at the controllable distance.
Measurement place
A place that is nothing of extreme light reflected in the room.
External light
Project the light of ordinary white fluorescent lamps which are not high
Frequency lamps and must be less then 10 Lux at the module surface.
(Ee≦10Lux)
Standard transmitter
A transmitter whose output is so adjusted as to Vo = 400 mVp-p and the output
Wave form shown in Fig.-1.According to the measurement method shown in
Fig.-2 the standard transmitter is specified.
However, the infrared photodiode to be used for the transmitter should be
λp=940nm, ∆λ=50nm. Regarding photo diode, sensitivity S=26nA/Lx
in case light source temperature 2856°K, Ee=100Lx, Vr=5V.
Measuring system
According to the measuring system shown in Fig.-3
Block Diagram：
BGR
IN
Input AGC
Post
Amp.
AGC
Oscillator Control
Waveform
BPF
Detector &
ATC
Fc set
Freq. Trimming
selection
VCC
Waveform
Rectifier
42Kohm
OUT
GND
Everlight Electronics Co., Ltd.
： Device No SZDMO-036-112
http://www.everlight.com
： Prepared date Jan. 18, 08
Rev 1 Page: 4 of 12
： Prepared by Huayan.Peng
Share Link: 