KS8721BL データシートの表示（PDF） - Micrel

部品番号

コンポーネント説明

メーカー

KS8721BL

3.3V Single Power Supply 10/100BASE-TX/FX MII Physical Layer Transceiver

Micrel 

Micrel, Inc.

KS8721BL/SL

Strapping Options(1)

Pin Number

6, 5,

4, 3

25

9(3)

11(3)

21(3)

22(3)

27

Pin Name

PHYAD[4:1]/

RXD[0:3]

PHYAD0/

INT#

PCS_LPBK/

RXDV

ISO/RXER

RMII/COL

RMII_BTB

CRS

SPD100/

No FEF/

28

DUPLEX/

LED2

29

NWAYEN/

LED3

30

PD#

Type(2)

Ipd/O

Ipu/O

Ipd/O

Ipd/O

Ipd/O

Ipd/O

Ipu/O

Ipu/O

Ipu/O

Ipu

Pin Function

PHY Address latched at power-up/reset. The default PHY address is 00001.

Enables PCS_LPBK mode at power-up/reset. PD (default) = Disable, PU = Enable.

Enables ISOLATE mode at power-up/reset. PD (default) = Disable, PU = Enable.

Enables RMII mode at power-up/reset. PD (default) = Disable, PU = Enable.

Enable RMII back-to-back mode at power-up/reset. PD (default) = Disable,

PU = Enable.

Latched into Register 0h bit 13 during power-up/reset. PD = 10Mbps, PU (default) =

100Mbps. If SPD100 is asserted during power-up/reset, this pin is also latched as

LED1 the Speed Support in register 4h. (If FXEN is pulled up, the latched value 0

means no Far_End _Fault.)

Latched into Register 0h bit 8 during power-up/reset. PD = Half-duplex, PU (default) =

Full-duplex. If Duplex is pulled up during reset, this pin is also latched as the Duplex

support in register 4h.

Nway (auto-negotiation) Enable. Latched into Register 0h bit 12 during power-up/reset.

PD = Disable Auto-Negotiation, PU (default) = Enable Auto-Negotiation.

Power-Down Enable. PU (default) = Normal operation, PD = Power-Down mode.

Notes:

1.

2.

3.

Strap-in is latched during power-up or reset.

Ipu = Input with internal pull-up.

Ipd/O = Input with internal pull-down during reset; output pin otherwise.

Ipu/O = Input with internal pull-up during reset; output pin otherwise.

See “Reference Circuit” section for pull-up/pull-down and float information.

Some devices may drive MII pins that are designated as output (PHY) on power-up, resulting in incorrect strapping values latched at reset.

It is recommended that an external pull-down via 1kΩ resistor be used in these applications to augment the 8721’s internal pull-down.

June 2009

10

M9999-062509-1.3

Share Link: