Block Diagram
LC74770M
Display Control Commands
Display control commands have an 8-bit format and are transferred using the serial input function. Commands consist of
a command identification code in the first byte and command data in the following bytes. The following commands are
supported.
1 COMMAND 0: Display memory (VRAM) write address setup command
2 COMMAND 1: Display character data write command
3 COMMAND 2: Vertical display start position and vertical character size setup command
4 COMMAND 3: Horizontal display start position and horizontal character size setup command
5 COMMAND 4: Display control setup command
6 COMMAND 5: System 2 (BLK2 and CHA2) output control (lines 1 to 6) and line size setting command
7 COMMAND 6: System 2 (BLK2 and CHA2) output control (lines 7 to 12) and general-purpose port setting command
No. 4248-4/11