LS7366R データシートの表示（PDF） - LSI Corporation

部品番号

コンポーネント説明

メーカー

LS7366R

32-BIT QUADRATURE COUNTER WITH SERIAL INTERFACE

LSI Corporation  

MDR0. The MDR0 (Mode Register 0) is an 8-bit read/write register that sets up the operating mode for the LS7366R. The MDR0 is

written into by executing the "write-to-MDR0" instruction via the instruction register. Upon power up MDR0 is cleared to zero. The

following is a breakdown of the MDR bits:

B7 B6 B5 B4 B3 B2 B1 B0

B1 B0 = 00: non-quadrature count mode. (A = clock, B = direction).

= 01: x1 quadrature count mode (one count per quadrature cycle).

= 10: x2 quadrature count mode (two counts per quadrature cycle).

= 11: x4 quadrature count mode (four counts per quadrature cycle).

B3 B2 = 00: free-running count mode.

= 01: single-cycle count mode (counter disabled with carry or borrow, re-enabled with reset or load).

= 10: range-limit count mode (up and down count-ranges are limited between DTR and zero,

respectively; counting freezes at these limits but resumes when direction reverses).

= 11: modulo-n count mode (input count clock frequency is divided by a factor of (n+1),

where n = DTR, in both up and down directions).

B5 B4 = 00: disable index.

= 01: configure index as the "load CNTR" input (transfers DTR to CNTR).

= 10: configure index as the "reset CNTR" input (clears CNTR to 0).

= 11: configure index as the "load OTR" input (transfers CNTR to OTR).

B6 = 0: Asynchronous Index

= 1: Synchronous Index (overridden in non-quadrature mode)

B7 = 0: Filter clock division factor = 1

= 1: Filter clock division factor = 2

MDR1. The MDR1 (Mode Register 1) is an 8-bit read/write register which is appended to MDR0 for additional modes.

Upon power-up MDR1 is cleared to zero.

B7 B6 B5 B4 B3 B2 B1 B0

B1 B0 = 00: 4-byte counter mode

= 01: 3-byte counter mode

= 10: 2-byte counter mode.

= 11: 1-byte counter mode

B2 = 0: Enable counting

= 1: Disable counting

B3 = : not used

B4 = 0: NOP

= 1: FLAG on IDX (B4 of STR)

B5 = 0: NOP

= 1: FLAG on CMP (B5 of STR)

B6 = 0: NOP

= 1: FLAG on BW (B6 of STR)

B7 = 0: NOP

= 1: FLAG on CY (B7 of STR)

NOTE: Applicable to both

LFLAG/ and DFLAG/

ABSOLUTE MAXIMUM RATINGS:

(All voltages referenced to Vss)

Parameter

DC Supply Voltage

Input Voltage

Operating Temperature

Storage Temperature

Symbol

VDD

VIN

TA

TSTG

Values

+7.0

Vss - 0.3 to VDD + 0.3

-25 to +80

65 to +150

Unit

V

V

oC

oC

7366R-041906-4

Share Link: