LTC1458CG データシートの表示（PDF） - Linear Technology

部品番号

コンポーネント説明

メーカー

LTC1458CG

Quad 12-Bit Rail-to-Rail Micropower DACs

Linear Technology 

LTC1458/LTC1458L

DEFI ITIO S

Differential Nonlinearity (DNL): DNL is the difference

between the measured change and the ideal 1LSB change

between any two adjacent codes. The DNL error between

any two codes is calculated as follows:

DNL = (∆VOUT – LSB)/LSB

∆VOUT = The measured voltage difference between

two adjacent codes

Digital Feedthrough: The glitch that appears at the analog

output caused by AC coupling from the digital inputs when

they change state. The area of the glitch is specified in

(nV)(sec).

U

OPERATIO

Serial Interface

The data on the DIN input is loaded into the shift register

on the rising edge of the clock. Data is loaded as one 48-bit

word, DAC A first, then DAC B, DAC C and DAC D. The MSB

is loaded first for each DAC. The DAC registers load the

data from the shift register when CS/LD is pulled high. The

CLK is disabled internally when CS/LD is high. Note: CLK

must be low before CS/LD is pulled low to avoid an extra

internal clock pulse.

The buffered output of the 48-bit shift register is available

on the DOUT pin which swings from ground to VCC.

Multiple LTC1458/LTC1458Ls may be daisy-chained to-

gether by connecting the DOUT pin to the DIN pin of the next

chip, while the CLK and CS/LD signals remain common to

all chips in the daisy-chain. The serial data is clocked to all

of the chips, then the CS/LD signal is pulled high to update

all of them simultaneously.

Reference

The LTC1458L has an internal reference of 1.22V with a full

scale of 2.5V (gain of 2 configuration). The LTC1458

includes an internal 2.048V reference, making 1LSB equal

to 1mV (gain of 2 configuration). When the buffer gain is

2, the external reference must be less than VCC/2 and be

capable of driving the 15k minimum DAC resistor ladder.

The external reference must always be less than

VCC – 1.5V. The reference output voltage noise spectral

density at 1kHz is 300nV/√Hz.

Voltage Output

The rail-to-rail buffered output of the LTC1458 family can

source or sink 5mA when operating with a 5V supply over

the entire operating temperature range while pulling to

within 300mV of the positive supply voltage or ground.

The output swings to within a few millivolts of either

supply rail when unloaded and has an equivalent output

resistance of 40Ω when driving a load to the rails. The

output can drive 1000pF without going into oscillation.

The output voltage noise spectral density at 1kHz is

600nV/√Hz.

8

Share Link: