LTC3541-2(RevA) データシートの表示（PDF） - Linear Technology

部品番号

コンポーネント説明

メーカー

LTC3541-2
(Rev.:RevA)

High Efficiency Buck + VLDO Regulator

Linear Technology 

U

OPERATIO

Transitioning from linear regulator mode to VLDO mode,

accomplished by bringing ENBUCK from a logic low to a

logic high while ENVLDO is a logic high, is designed to be

as seamless and transient free as possible. The precise

transient response of LVOUT due to this transition is a

function of COUT and the load current. Waveforms given

in the Typical Performance Characteristics section show

typical transient responses using the minimum COUT of

2.2µF and load currents of 1mA and 30mA respectively.

Generally, the amplitude of any transients present will

decrease as COUT is increased. To ensure reliable operation

and adherence to the load regulation limits presented in

the Electrical Characterstics table, the load current must

not exceed the linear regulator IOUT limit of 30mA within

20ms after ENBUCK has transitioned to a logic high. The

300mA IOUT limit of VLDO applies thereafter. Further,

for configurations that do not use the LTC3541-2’s buck

regulator to provide the VLDO input voltage (LVIN), the user

must ensure a stable LVIN voltage is present no less than

1ms prior to ENBUCK transitioning to a logic high.

LTC3541-2

In a similar manner, transitioning from VLDO mode to

linear regulator mode, accomplished by bringing ENBUCK

from a high low to a logic low while ENVLDO is a logic

high, is designed to be as seamless and transient free as

possible. Again, the precise transient response of LVOUT

due to this transition is a function of COUT and the load

current. Waveforms given in the Typical Performance

Characteristics section show typical transient responses

using the minimum COUT of 2.2µF and load currents of

1mA and 30mA respectively. Generally, the amplitude of

any transients present will decrease as COUT is increased.

To ensure reliable operation and adherence to the load

regulation limits presented in the Electrical Characterstics

table, the load current must not exceed the linear regulator

IOUT limit of 30mA 1ms prior to ENBUCK transitioning to

a logic low and thereafer. Further, for configurations that

do not use the LTC3541-2’s buck regulator to provide the

VLDO input voltage (LVIN), the user must continue to ensure

a stable LVIN voltage no less than 1ms after ENBUCK has

transitioned to a logic low.

35412fb

11

Share Link: