M69AW024BE データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

M69AW024BE

16 Mbit (1M x16) 3V Asynchronous PSRAM

STMicroelectronics 

M69AW024BE

SIGNAL DESCRIPTIONS

See Figure 2., Logic Diagram, and Table

1., Signal Names, for a brief overview of the sig-

nals connected to this device.

Address Inputs (A0-A19). The Address Inputs

select the cells in the memory array to access dur-

ing Read and Write operations.

Data Inputs/Outputs (DQ8-DQ15). The Upper

Byte Data Inputs/Outputs carry the data to or from

the upper part of the selected address during a

Write or Read operation, when Upper Byte Enable

(UB) is driven Low.

Data Inputs/Outputs (DQ0-DQ7). The Lower

Byte Data Inputs/Outputs carry the data to or from

the lower part of the selected address during a

Write or Read operation, when Lower Byte Enable

(LB) is driven Low.

Chip Enable (E1). When asserted (Low), the

Chip Enable, E1, activates the memory state ma-

chine, address buffers and decoders, allowing

Read and Write operations to be performed. When

de-asserted (High), all other pins are ignored, and

the device is put, automatically, in low-power

Standby mode.

Chip Enable (E2). The Chip Enable, E2, puts the

device in Deep Power-down mode when it

is driven Low. This is the lowest power mode.

Output Enable (G). The Output Enable, G, pro-

vides a high speed tri-state control, allowing fast

read/write cycles to be achieved with the common

I/O data bus.

Write Enable (W). The Write Enable, W, controls

the Bus Write operation of the memory’s Com-

mand Interface.

Upper Byte Enable (UB). The Upper Byte En-

able, UB, gates the data on the Upper Byte Data

Inputs/Outputs (DQ8-DQ15) to or from the upper

part of the selected address during a Write or

Read operation.

Lower Byte Enable (LB). The Lower Byte En-

able, LB, gates the data on the Lower Byte Data

Inputs/Outputs (DQ0-DQ7) to or from the lower

part of the selected address during a Write or

Read operation.

VCC Supply Voltage. The VCC Supply Voltage

supplies the power for all operations (Read or

Write) and for driving the refresh logic, even when

the device is not being accessed.

VSS Ground. The VSS Ground is the reference for

all voltage measurements.

6/25

Share Link: