MACH211SP-10 データシートの表示（PDF） - Unspecified

部品番号

コンポーネント説明

メーカー

MACH211SP-10

High-Performance EE CMOS In-System Programmable Logic

Unspecified 

VANTIS

The Macrocell

The MACH211SP has two types of macrocell: output and buried. The output macrocells can be

configured as either registered, latched, or combinatorial, with programmable polarity. The

macrocell provides internal feedback whether configured with or without the flip-flop. The

registers can be configured as D-type or T-type, allowing for product-term optimization.

The flip-flops can individually select one of two clock/gate pins, which are also available as data

inputs. The registers are clocked on the LOW-to-HIGH transition of the clock signal. The latch

holds its data when the gate input is HIGH, and is transparent when the gate input is LOW. The

flip-flops can also be asynchronously initialized with the common asynchronous reset and preset

product terms.

The buried macrocells are the same as the output macrocells if they are used for generating logic.

In that case, the only thing that distinguishes them from the output macrocells is the fact that there

is no I/O cell connection, and the signal is only used internally. The buried macrocell can also be

configured as an input register or latch.

The I/O Cell

The I/O cell in the MACH211SP consists of a three-state output buffer. The three-state buffer can

be configured in one of three ways: always enabled, always disabled, or controlled by a product

term. If product term control is chosen, one of two product terms may be used to provide the

control. The two product terms that are available are common to all I/O cells in a PAL block.

These choices make it possible to use the macrocell as an output, an input, a bidirectional pin, or

a three-state output for use in driving a bus.

SpeedLocking for Guaranteed Fixed Timing

The unique MACH 1 & 2 architecture is designed for high performance—a metric that is met in

both raw speed, but even more importantly, guaranteed fixed speed. Using the design of the

central switch matrix, the MACH211SP product offers the SpeedLocking feature, which allows a

stable fixed pin-to-pin delay, independent of logic paths, routing resources and design refits for

up to 16 product terms per output. Other non-Vantis CPLDs incur serious timing delays as product

terms expand beyond their typical 4 or 5 product-term limits. Speed and SpeedLocking combine

for continuous, high performance required in today's demanding designs.

In-System Programming

Programming is the process where MACH devices are loaded with a pattern defined in a JEDEC

file obtained from MACHXL software or third-party software. Programming is accomplished

through four JTAG pins: Test Mode Select (TMS), Test Clock (TCK), Test Data In (TDI), and Test

Data Out (TDO). The MACH211SP can be deployed in any JTAG (IEEE 1149.1) compliant chain.

While the MACH211SP is fully JTAG compatible, it supports the BYPASS instruction, not the

EXTEST and SAMPLE/PRELOAD instructions. The MACH211SP can be programmed across the

commercial temperature range. Programming the MACH device after it has been placed on a circuit

board is easily accomplished. Programming is initiated by placing the device into programming

mode, using the MACHPRO programming software provided by Vantis. The device is bulk erased

and the JEDEC file is then loaded. After the data is transferred into the device, the PROGRAM

instruction is loaded.

MACH211SP-7/10/12/15

9

Share Link: