MAX713CSE(2002) データシートの表示（PDF） - Maxim Integrated
部品番号
コンポーネント説明
メーカー
MAX713CSE Datasheet PDF : 17 Pages
| |||
NiCd/NiMH Battery
Fast-Charge Controllers
HOT
+2.0V
COLD
REF
R3
THI
R4
TEMP
TLO
IN THERMAL
CONTACT WITH
BATTERY
T1
AMBIENT
0.022µF TEMPERATURE
R5
T2
MAX712
MAX713
BATT-
T3 0.022µF 1µF
AMBIENT
TEMPERATURE
NOTE: FOR ABSOLUTE TEMPERATURE CHARGE CUTOFF, T2 AND T3 CAN BE
REPLACED BY STANDARD RESISTORS.
Figure 9a. Temperature Comparators
AMBIENT
REF
TEMPERATURE
T2
THI
HOT
R5
R3
+2.0V
COLD
TEMP
TLO
0.022µF 0.022µF
1µF
R4
MAX712
MAX713
BATT-
T1
T3
IN THERMAL
AMBIENT
CONTACT WITH TEMPERATURE
BATTERY
NOTE: FOR ABSOLUTE TEMPERATURE CHARGE CUTOFF, T2 AND T3 CAN BE
REPLACED BY STANDARD RESISTORS.
Figure 9b. Alternative Temperature Comparator Configuration
terminal. In this case, use the configuration shown in
Figure 9b. Thermistors T2 and T3 can be replaced by
standard resistors if absolute temperature charge cut-
off is acceptable. All resistance values in Figures 9a
and 9b should be chosen in the 10kΩ to 500kΩ range.
__________Applications Information
Switch-Mode Operation
For applications where the power dissipation in the
pass transistor cannot be tolerated (ie., where heat
sinking is not feasible or is too costly), a switch-mode
charger is recommended.
Switch-mode operation can be implemented simply by
using the circuit of Figure 19. The circuit of Figure 19
uses the error amplifier at the CC pin as a comparator
with the 33pF capacitor adding hysteresis. Figure 19 is
shown configured to charge two cells at 1A. Lower
charge currents and a different number of cells can be
accommodated simply by changing RSENSE and
PGM0–PGM3 connections (Tables 2 and 3).
The input power-supply voltage range is 8V to 15V and
must be at least 2V greater than the peak battery
voltage, under fast charge. As shown in Figure 19, the
source should be capable of greater than 1.3A of
output current. The source requirements are critical
because if violated, proper termination of the fast-
charge cycle might not occur. For input voltages
greater than 15V, see the MAX713SWEVKIT data sheet.
11
10
HIGH PEAK
9
8
120Hz RIPPLE
7
LOW PEAK
6
0
200 400 600 800 1000
LOAD CURRENT (mA)
Figure 10. Sony Radio AC Adapter AC-190 Load Characteristic,
9VDC 800mA
______________________________________________________________________________________ 13
Share Link: 