MAX712CSE(2002) データシートの表示（PDF） - Maxim Integrated

部品番号

コンポーネント説明

メーカー

MAX712CSE
(Rev.:2002)

NiCd/NiMH Battery Fast-Charge Controllers

Maxim Integrated 

NiCd/NiMH Battery

Fast-Charge Controllers

Pin Description

PIN

1

2

3, 4

5

6

7

8

9, 10

11

12

13

14

15

16

NAME

VLIMIT

BATT+

FUNCTION

Sets the maximum cell voltage. The battery terminal voltage (BATT+ - BATT-) will not exceed VLIMIT x

(number of cells). Do not allow VLIMIT to exceed 2.5V. Tie VLIMIT to VREF for normal operation.

Positive terminal of battery

PGM0,

PGM1

PGM0 and PGM1 set the number of series cells to be charged. The number of cells can be set from

1 to 16 by connecting PGM0 and PGM1 to any of V+, REF, or BATT-, or by leaving the pin open (Table

2). For cell counts greater than 11, see the Linear-Mode, High Series Cell Count section. Charging more

or fewer cells than the number programmed may inhibit ∆V fast-charge termination.

THI

TLO

TEMP

FASTCHG

PGM2,

PGM3

Trip point for the over-temperature comparator. If the voltage-on TEMP rises above THI, fast charge ends.

Trip point for the under-temperature comparator. If the MAX712/MAX713 power on with the voltage-on

TEMP less than TLO, fast charge is inhibited and will not start until TEMP rises above TLO.

Sense input for temperature-dependent voltage from thermistors.

Open-drain, fast-charge status output. While the MAX712/MAX713 fast charge the battery, FASTCHG

sinks current. When charge ends and trickle charge begins, FASTCHG stops sinking current.

PGM2 and PGM3 set the maximum time allowed for fast charging. Timeouts from 33 minutes to 264

minutes can be set by connecting to any of V+, REF, or BATT-, or by leaving the pin open (Table 3).

PGM3 also sets the fast-charge to trickle-charge current ratio (Table 5).

CC

BATT-

GND

DRV

V+

REF

Compensation input for constant current regulation loop

Negative terminal of battery

System ground. The resistor placed between BATT- and GND monitors the current into the battery.

Current sink for driving the external PNP current source

Shunt regulator. The voltage on V+ is regulated to +5V with respect to BATT-, and the shunt current

powers the MAX712/MAX713.

2V reference output

_______________________________________________________________________________________ 5

Share Link: