MB89120 データシートの表示（PDF） - Fujitsu

部品番号

コンポーネント説明

メーカー

MB89120

8-bit Proprietary Microcontroller

Fujitsu 

MB89120/120A Series

s HANDLING DEVICES

1. Preventing Latchup

Latchup may occur on CMOS ICs if voltage higher than VCC or lower than VSS is applied to input and output pins

other than medium- and high- voltage pins, or if higher than the voltage which shows on “1. Absolute Maximum

Ratings” in “s ELECTRICAL CHARACTERISTICS” is applied between VCC and VSS.

When latchup occurs, power supply current increases rapidly, and might thermally damage elements. When

using, take great care not to exceed the absolute maximum ratings.

Also, take care to prevent the analog power supply (AVCC and AVR) and analog input from exceeding the digital

power supply (VCC) when the analog system power supply is turned on and off.

2. Treatment of Unused Input Pins

Leaving unused input pins open could cause malfunctions. They should be connected to pull-up or pull-down

resistor.

3. Treatment of N.C. Pins

Be sure to leave (internally connected) N.C. pins open.

4. Power Supply Voltage Fluctuations

Although operation is assured within the rated range of VCC power supply voltage, a rapid fluctuation of the

voltage could cause malfunctions, even if it occurs within the rated range. Stabilizing voltage supplied to the IC

is therefore important. As stabilization guidelines, it is recommended to control power so that VCC ripple fluctu-

ations (P-P value) will be less than 10% of the standard VCC value at the commercial frequency (50 to 60 Hz)

and the transient fluctuation rate will be less than 0.1 V/ms at the time of a momentary fluctuation such as when

power is switched.

5. Precautions when Using an External Clock

When an external clock is used, oscillation stabilization time is required even for power-on reset (optional) and

release from stop mode.

6. Turning on the supply voltage (only for the MB89P135A)

When the power supply is turned on if MB89P135A is used, power on sharply up to 2.0 V within 13 clock cycles

after starting of oscillation.

Further, various option may be set, if power supply up to keep this condition.

10

Share Link: