MB90340E データシートの表示（PDF） - Fujitsu

部品番号

コンポーネント説明

メーカー

MB90340E

16-bit Microcontroller

Fujitsu 

MB90340E Series

Pin No.

QFP100*1 LQFP100*2

9

7

10

8

11

9

12

10

13, 14

11, 12

15

13

16

14

17

15

18

16

Pin name

P34

HRQ

OUT4

P35

HAK

OUT5

P36

RDY

OUT6

P37

CLK

OUT7

P40, P41

X0A , X1A

VCC

VSS

C

P42

IN6

RX1

INT9R

I/O

Circuit

type*3

Function

General purpose I/O pin. The register can be set to select

whether to use a pull-up resistor. This function is enabled either

in single-chip mode or when the hold function is disabled.

G Hold request input pin. This function is enabled when both the

external bus and the hold function are enabled.

Waveform output pin for output compare.

General purpose I/O pin. The register can be set to select

whether to use a pull-up resistor. This function is enabled either

in single-chip mode or when the hold function is disabled.

G Hold acknowledge output pin. This function is enabled when

both the external bus and the hold function are enabled.

Waveform output pin for output compare.

General purpose I/O pin. The register can be set to select

whether to use a pull-up resistor. This function is enabled either

in single-chip mode or when the external ready function is

G disabled.

External ready input pin. This function is enabled when both the

external bus and the external ready function are enabled.

Waveform output pin for output compare.

General purpose I/O pin. The register can be set to select

whether to use a pull-up resistor. This function is enabled either

in single-chip mode or when the clock output is disabled.

G Clock output pin. This function is enabled when both the

external bus and clock output are enabled.

Waveform output pin for output compare OCU7

General purpose I/O pins.

F (devices with an S suffix in the part number and or

MB90V340E-101)

Oscillation pins for sub clock

B (devices without an S suffix in the part number and or

MB90V340E-102)

⎯ Power (3.5 V to 5.5 V) input pin

⎯ GND pin

This is the power supply stabilization capacitor This pin should

K be connected to a ceramic capacitor with a capacitance greater

than or equal to 0.1 µF.

General purpose I/O pin.

Trigger input pin for input capture.

F RX input pin for CAN1 Interface

(MB90341E/342E/F342E/F343E/F345E only)

External interrupt request input pin

(Continued)

12

Share Link: